资源列表
SpringNet_Lesson5
- spring.net 入门教程，根据章节内容提供参考的代码源码-Spring' s Getting Started tutorial chapters provide reference code source
SpringNet_Lesson6
- spring.net 入门教程，根据章节内容提供参考的代码源码-Spring' s Getting Started tutorial chapters provide reference code source
C-emis12
- C语言项目 简单的银行系统项目开发 为linux学习提供了基础-C language projects
gpiops_v1_01_a
- zedboard开发板gpio ps部分调试源码， 可以在linux下编译也可在xilinx的sdk中编译-zedboard development board gpio ps some debugging source code can be compiled under linux can also be compiled in a xilinx sdk
iicps_v1_02_a
- xilinx的硬核iic总线裸板调试源码， 可以在linux下编译也可在xilinx的sdk中编译-xilinx iic bus hardcore bare board debugging source code can be compiled under linux can also compile the xilinx sdk
leds.tar
- 嵌入式linux下的LED驱动程序示例。通过led演示了嵌入式linux的驱动程序设计规范和流程。-An led driver demo for embedded linux. It shows how to build a linux driver by a simple led program.
mmu.tar
- 嵌入式ARM的mmu操作示例。设置MMU使得外部SDRAM可用，然后对比led测试程序在内部RAM和外部RAM上的运行速度。-A mmu operation demo for embedded arm. This program set the mmu of arm and make external SDRAM usable, then we compare the excutting speed of a led test program between internal SRAM and
uart
- A8裸板串口驱动，适用于s5pc100开发板。-A8 bare board serial port driver, applicable to Yu s5pc100 development board.
stepper
- linux下基于S3C2440的步进电机驱动测试应用程序，控制端输入字符直接控制速度和方向-linux under the Based on S3C2440' s stepper motor driver test application procedures, control-ended input character directly control the speed and direction
pcf8591
- linux下通过S3C2440开发板的I2C接口控制8位ADC转换器pcf851-linux S3C2440 development board through the I2C interface control 8-bit ADC converter pcf851
nuc140-i2c-s3c2440
- linux下S3C2440通过I2C跟nuc单片机互通，关键是单片机i2c地址的选择很坑爹，试了很久终于成功打通了-Under linux S3C2440 microcontroller via I2C with nuc interoperability, the key is the choice of microcontroller i2c address very pit father, tried for a long time and finally succeeded to get
average-pcf8591
- linux下S3C2440控制PCF8591，读取4通道数据并计算平均值。关键点是，每次读取必须抛掉第一个数据，有效数据从第二个算起-S3C2440 linux under control PCF8591, 4-channel data read and calculate the average. The key point is that each read data to discard the first valid data from the second counting! ! !