资源列表
linux-video
- 嵌入式Linux视频!底层驱动相关视频-Embedded Linux Video! Underlying driver related videos!
ae63abe6f4bb
- 在S3C2410上通过对红外多功能口进行配置实现红外收发功能-Configured to achieve S3C2410 infrared transceiver functionality on multifunction infrared port by
qtmcom_loop_onetoone
- 可实现两个串口互相通讯，界面友好，在Qt4环境下可直接运行。-realized between two serial communications, user-friendly, in Qt4 environment can be directly run
demo_test6410_sys
- s3c6410demo功能演示：要求分别能对LED，BUTTON，ADC，PWM蜂鸣器，定时器，看门狗，RTC等模块进行功能测试。-s3c6410demo function demonstrating the s3c6410demo function demo: requirements for functional testing of LEDs, the BUTTON, the ADC, PWM buzzer, timer, Watchdog, RTC and other modules.
u-boot-1.1.6_patch
- U-boot1.1.6 补丁，用于友善之臂QQs3c2440开发板支持nand flash,nor flash启动，直接patch到u-boot1.1.6中即可使用。-U-boot1.1.6 patch for the development friendliness of the arm QQs3c2440 board support nand flash, nor flash boot directly to the u-boot1.1.6 in the patch can be used.
Driver-development-on-embedded-LINUX-Study
- 基于嵌入式LINUX驱动程序开发的研究 ．设备驱动程序及其功能 设备驱动程序开发过程-Driver development on embedded LINUX research. Device drivers and functional device driver development process
sg_utils-1.02
- 嵌入式linux下的scsi测试源代码sg_utils-1.02-Embedded linux source code under test scsi
uClinux-cmp
- 这是一篇关于uclinux触摸屏设计的文章。-This is a touch screen on the Design Basis article.
ADS7843
- 基于uClinux触摸屏的设计。
IMX233
- its is ARM 9 SBC Designed in Eagle 5.11 with schematic. IMX233 with 64mb Ram , External boot from SD card. Compost Video and GPIO Interface with USART and UART. dual layer pcb-its is ARM 9 SBC Designed in Eagle 5.11 with schematic. IMX233 with 64mb R
GyroRecv-sim
- 基于Tinyos的无线传感网中基站接收源代码，具有简单适配预定结构体接收转发至串口的功能，适用于几乎所有的无线传感节点，如shimmer2r，iris等-A simple Tinyos-based base station source code in wireless sensor network, applicable to almost all wireless sensor nodes, such as shimmer2r, iris, etc.
linux-2.6.27.8-lpc3250
- NXP 的ARM9 （LPC3250）硬件平台下 确实可用的Linux kernel 源代码的patch 文件。请在linux 用patch 命令对linux-2.6.27.8 进行升级后使用。NXP的同一系列的其他CPU应该也可以用。-NXP是ARM9 (LPC3250) hardware platforms does the Linux kernel source code available in the patch file. Please use the linux command o