资源列表
chuankou
- 用中断法编出串行口方式1下的发送程序。设单片机主频为6MHZ，定时器T1用作波特率发生器，波特率为2400b/s，发送字符块在内部RAM的起始地址为TBLOCK单元，字符块长度为LEN。要求奇校验位在数据第8位发送，字符块长度LEN率先发送。-Send serial port interrupt method to compile the program. Let microcontroller clocked at 6MHZ, timer T1 as baud rate generator,
danpianji
- 利用定时器T1的模式2对T1引脚输入的外部信号计数，要求计满100个脉冲，将P1.0引脚取反。-External signal on T1 pin count of timer T1 mode requires the expiration of the 100 pulse P1.0 pin negated.
xinhaodeng
- 根据单片机编程原理实现对交通信号灯的控制-Control of traffic lights based on the principle of microcontroller programming
lcd1602
- Atmega128l连接1602显示屏的一个小实例-Atmega128l connected to a small example of the 1602 display
main
- atmega128l驱动led的一个小实例-atmega128l drive led a small example
source
- DS18B20 测试温度并在数码管上显示-DS18B20 test temperature on the digital display
eeprom
- 利用EEPROM记录开机次数，利用数码管显示结果。-The EEPROM record boot times, digital tube display results.
LCD1602
- LCD1602液晶进行倒计时的同时另进行蜂鸣器的报警-The LCD1602 LCD countdown while another buzzer alarm
Usart
- 计算机通过串口向开发板发送数据，开发板将数据原样送回。-Computer through the serial port to send data to the development board, development board sent back to the data intact.
PCF8563
- 利用PCF8563定时，蜂鸣器隔1秒鸣叫。-PCF8563 timing buzzer every one second tweet.
jidianqi4
- 基于stc89c52的关于继电器控制小车的程序-Program based stc89c52 relay control car
DS18B20
- DS18B20在STC12S上实际实现。并且提供完成仿真图-The DS18B20 STC12S on the actual implementation. And provides complete simulation Figure