资源列表
ARM
- ARM嵌入式系统硬件设计及应用实例 -arm develpmengt
schematic
- 51单片机最小系统原理图，方便设计师设计参考-51 SCM minimum system schematics, convenient designers reference
51单片机的常用例程
- 51单片机的常用例程，方便大型工程中直接调用-51 microcontroller used routines, direct calls to facilitate the large-scale projects
fridge--kongwensheji
- 单片机控温系统设计，需用KEIL导入用proteus模拟电冰箱液晶现实器！-SCM temperature control system design, required KEIL introducing proteus simulation refrigerators LCD reality is!
STM32-low-power
- STM32单片机的低功耗，可以达到0.1mA 已经成功。-The STM32 microcontroller low-power, up to 0.1mA has been successful.
freescaleCCDdoubleLine
- 单片机XS128，实现智能车寻双黑线跑，开发环境code warrior IDE-freescale XS128
dianti
- 此程序是模拟电梯上下开门。一共有四楼，每一层都可以开关门。-This program is to simulate the elevator up and down to open the door. A total of the fourth floor, each layer can switch doors.
G2553-to-1602
- 使用微处理器MSP430G2553控制液晶显示器1602-Use the microprocessor MSP430G2553 control LCD display 1602
caculator
- 用微处理器MSP430G2553实现矩阵键盘计算器-With the microprocessor MSP430G2553 achieve matrix keyboard calculator
temp_control
- 使用MSP430G2xxx应用PID算法完成的温度控制-Temperature control PID algorithm use MSP430G2xxx application completed
TLV5616(For_MSP430)
- 1、本程序的前提是CS引脚接地，基准电压设定为1.372V 2、“data=temp*4096/2.745”语句是为了实现将所需输出的模拟值直接转化为编码，减少计算量 3、TLV5616最大输出电压是基准电压的两倍，输出电压最大范围是0~Vdd-0.1V,另外基准电压的输入范围为0~Vdd-1.5V(TLV5616文档中有注明，使用时请注意) -1, the premise of this program the CS pin grounded, the reference volt
Temperature-humidity-
- 温湿度检测系统，用于温度和湿度的检测，显示以及报警系统。-Temperature and humidity detection system