资源列表
LT-1B-Programs
- 郭天祥老师msp430教程中示例程序 适于初学者学习-msp430 program
STC89C52RC-DS1302PLCD1602
- STC89C52RC系列51单片机控制DS1302时钟芯片和LCD1602显示时间asm源码及hex代码打包，不同I/O口，可能需要稍微改写-STC89C52RC series of 51 single-chip control DS1302 clock chip and LCD1602 display time asm source code and hex code package, the different I/O port, you may need some redrafting
APC220
- 介绍APC220无线传输模块的使用，以及用51单片机测试程序。介绍上位机与下位机的数据传输方式。-Introduction APC220 wireless transmission module used, and with 51 testing procedures. Introduction PC and the next crew of the data transmission.
PCF8563PRTC
- PCF8563 实时时钟程序，基于51单片机的程序，希望对大家有所帮助-PCF8563 real time clock program
123
- LCD1602、AT89C51、ADC0809、数字电压表、串口通信、独立按键 基于89C51交流电力智能传感器系统设计-LCD1602, AT89C51, ADC0809, digital voltmeter, serial port communication, independent buttons Based on 89 c51 ac power intelligent sensor system design
2-2
- 在单片机开发板上程序使红黄绿灯会间隔点亮-Program in the microcontroller development board to make red, yellow, green light will illuminate interval
TestHT1621
- 51单片机开发HT1621液晶屏温度显示时间显示-51 MCU development HT1621 LCD screen display time temperature display
ks0108(LCM12864)PARM(STM32F103ZE)
- LCM12864内部KS0108控制器，STM32F103ZET6单片机，可显示动画图片，可移植性非常强，而且注释很详细，很容易看懂。-LCM12864 internal KS0108 controller, STM32F103ZET6 microcontroller, can display animated images, portability is very strong, and very detailed notes, it is easy to understand.
Light-up-experiments
- 单片机上点亮8个数码管的C程序，适合初学者参考学习-SCM lit eight digital tube C program
1.key_led
- C8051F320单片机按键例程,通过一个独立按键(接P0.0)控制7盏led灯的亮灭（按下即为0，led灯亮，反则灭）-C8051F320 MCU button routines, through a separate button (connected P0.0) control 7 led lamp light off (press is 0, led lights, anti then destroy)
5.watchdog
- C8051F320单片机看门狗程序，当接P0.0口的按键按下超过约524ms时，看门狗就会复位，并点亮全部的led灯（上电复位后led1已点亮）。-C8051F320 microcontroller watchdog program, when connected to P0.0 mouth more than about 524ms when the button is pressed, the watchdog will be reset, and all lit led lights (p
ADC1
- c8051f320单片机ADC程序，该实验通过AD转化，并把转化结果通过串口发送到pc机显示。-c8051f320 microcontroller ADC program, the experiment through the AD conversion, the conversion result and sent through the serial port to pc machine display.