资源列表
OLED-MCF52255
- OLED程序，基于飞思卡尔MCF52255单片机，基于code worried开发环境-OLED program, based on Freescale MCF52255 microcontroller development environment based on code worried
Temperature-Detection
- 课程设计，温度传感器的程序，使用DS18B20-Curriculum design, temperature sensor, the use of DS18B20
ma013
- 单片机开发系统演示程序,演示此程序需要配合串口调试软件（配套光盘已有此软件-Microcontroller development system demonstration program that demonstrates this program need to meet serial debugging software (CD-ROM has been supporting this software
CK_SHUMAGUAN
- 用kevi4写的 串口发送两位十六进制数码管显示十进制-With kevi4 write the serial transmit two decimal hexadecimal digital display
JTD
- 在keil环境下编写的交通灯，通过AT89C51扩展I/O口，接数码管显示时间，接键盘更改时间，按键e启动原来的时间，按键f后可更改两位的时间-In keil environment prepared by the traffic lights, through AT89C51 expansion I/O port, then digital tube display time, then the keyboard to change the time, the original start t
traffic-light-design
- 基于EasyARM2103人行过马路交通灯设计-Based EasyARM2103 pedestrian crossing traffic light design
89c52-water-light-source-
- 89c52流水灯源码，刷入即可使用哦，8颗LED-89c52 water light source, you can use the brush into the oh
bizhangche
- 基于51单片机，arduino编程的红外避障智能车-Based on 51 single-chip, arduino programming infrared obstacle avoidance Smart Car
sang
- 器采用数字波形合成技术,通过硬件电路和软件程序相结合,可输出自定义波形,如正弦波、方波、三角波、三角波、梯形波及其他任意波形，波形的频率和幅度在一定范围内可任意改变。波形和频率的改变通过软件控制，幅度的改变通过硬件实现。介绍了波形的生成原理、硬件电路和软件部分的设计原理。本系统可以产生最高频率798.6HZ的波形。该信号发生器具有体积小、价格低、性能稳定、功能齐全的优点-Uses digital waveform synthesis technology, hardware and softwa
isd4004_stm32_usart
- isd4004语音芯片，stm32控制，功能是录一段放一段，录的地址是一样的，掉电后录的还存在，这是个最简单的录放程序。-isd4004 voice chip, stm32 control function is to record a put a recorded address is the same, there are still recorded after power, which is the most simple recording program.
STM32F372_3xx_DS
- STM32F372XX/3xx的数据手册，共218页-STM32F372XX/3xx data sheet, total 218
STM32F37x_StdPeriph_Examples
- STM32F372XX的例子程序，使用库函数开发，包含所有外设程序。-STM32F372XX example, the use of library functions development, including all peripheral procedures.