资源列表
MCUPC
- 程序功能：MCU不停向PC机发送数据,在屏幕上显示0~127对应的ASCII字符 -Program features: MCU stop sending data to the PC, the screen display from 0 to 127 ASCII characters corresponding program features: MCU stop sending data to the PC, the screen corresponding to 0 to 127 ASCII
mcupc
- 接收来自PC机的字符，然后重新发送给PC机打开串口调试助手，正确设置通信格式，向学习板发送字符，观察MCU回发的字符-Receives a character from the PC, and then re-sent to the PC serial debugging assistant opens correctly set the communication format, send characters to the learning board, observe the MCU po
PCMCU
- PC通过串口调试精灵向MCU发送数据，MCU将其在1602液晶上显示-PC via the serial debug wizard to send data to the MCU, MCU will be displayed on the LCD in 1602
rs485
- 通过RS485端口不停地发送数据0xaa用示波器观察RS485端口A、B信号线上的波形或者用RS485接收器接收发送的字符。-Through the RS485 port to send data continuously 0xaa observed with an oscilloscope RS485 ports A, B signal waveforms or use the RS485 line receiver sends characters.
keypad
- 键盘扫描程序，采用中断20ms一次，按键数量可更改，扫描时间可调。-Keyboard scanning procedures, the use of interrupt 20 ms a, number keys can be changed, scan time is adjustable.
LCD
- realtouch开发板打的LCD驱动，包括简介和源码。-Realtouch development board LCD driver, including the introduction and source code.
LED1
- 基于MSP43014系列的单片机的LED闪烁，P2口的1、3、5、7口与0、2、4、6、8*替闪烁。-LED flash
AD9850
- 用于ＡＤ９８５０ 模拟ＤＤＳ输出，可输出方波，正弦波等数字或模拟波形，全数字化器件-AD9850 DDS for analog output can output square wave, sine wave and other digital or analog, digital devices
test
- 用于单片机驱动超声波探头发射接收，测量距离-MCU-driven ultrasonic probe for transmitting and receiving, measuring distance
Msp430-DS1302
- 采用MSP430单片机来驱动DS1302时钟芯片的程序代码！-Using MSP430 microcontroller to drive DS1302 clock chip code!
Cry12864
- 有关12864液晶显示的一些例程代码，用的是430单片机驱动的。-About 12,864 LCD some sample code, using a 430 chip-driven.
RS485
- 有关RS485通讯的详细的例程代码，所采用的是430的单片机。-For detailed RS485 communication routine code, using the microcontroller 430.