资源列表
huangyang-LED
- 基于89c52的花样流水灯，左右循环，以及花样的流水灯效果-Based 89c52 pattern of light water, about cycling, as well as patterns of light water effect
Hall
- 基于zigbee的霍尔传感器源代码，用IAR打开。-Hall sensor based on zigbee source code, use the IAR to open.
89c52-LED-shumaguan
- 基于89c52的数码管显示，单只数码管循环显示0-9-Based 89c52 digital display, single loop digital control display 0-9
FM1702SL
- 基于zigbee的FM的c程序源代码，需要用IAR打开。-Based on the zigbee FM c program source code, need to use IAR to open.
Motor
- 基于zigbee的电机的调试代码，需要用IAR打开。-Based on the zigbee motor debugging code, need to use IAR to open.
PWM
- 基于zigbee的PWM的c程序源代码，用IAR加入工程。-Based on zigbee PWM c program source code, using IAR to join the project.
Touch
- 基于zigbee的触摸扳源代码，需要用IAR打开。-Based on the zigbee touch pull the source code, need to use IAR to open.
STM32
- 数控直流电源，通过4*4按键输入所需电压，PWM调节BUCK电路的开关管的导通时间调节到你所需的电压-NC DC power supply via 4* 4 keypad enter the desired voltage, PWM BUCK regulator circuit switch conduction time adjusting to your desired voltage
StandSerialPIC18F2480
- 基于PIC18F2480的标准串口测试程序，程序使用硬件串口方式，局域MPLAB开发环境，程序使用的波特率是19200,1位起始位，8位数据位，1位停止位，编译器使用的是PIC18编译器，编译器没有选择正确将导致编译不成功，使用前需要先下载PIC18的编译器。-PIC18F2480 based standard serial test procedure uses hardware serial port, local MPLAB development environment, the pro
1.led
- 基于lm3s328单片机，采用直接操作寄存器的方法点亮一个led-Based lm3s328 microcontroller, using the direct method of operation register an led light
mcu-C-program
- 单片机C语言程序，包括热敏电阻测试数码管显示、超温报警、红外解码LCD显示等。-Microcontroller C language program, including a thermistor test digital display, over-temperature alarm, infrared decoding LCD display.
2.keyled
- 基于lm3s328单片机，采用直接操作寄存器实现案件点亮led.内涵proteus仿真和mdk源码-Based lm3s328 MCU, using direct manipulation of registers in case of light led. Connotations proteus simulation and mdk source