资源列表
ICR
- 红外线通信控制，使用配套的NEC遥控器，按下电源按键，继电器动作 -Infrared communication controller
LCD
- LCD显示驱动，使用8位并行接口,可以显示图形和字符-LCD display controller
8X8dianzhen
- 8X8点阵，实现了0到9的循环显示。适合初学者了解点阵扫描和取模的概念-8X8 matrix, to achieve the 0-9 loop display. Dot matrix scanning and suitable for beginners to understand the concept of modulo
Music-LZ
- 音乐播放－梁山伯与祝英台。单片机用T0中断在IO口P1.5输出乐曲-The output of music
Timer
- 定时器中断 24小时时钟程序，采用数码管-The timer interrupt
28BYJ48-5Vstepper-motor-speed
- 28BYJ48-5V电机调速程序，适合初学者，基于STC89C52，很典型-28BYJ48-5V motor speed control procedures, suitable for beginners, based on STC89C52, a typical
Ultrasonic-Ranging
- 利用超声波测距模块_HC-SR04进行超声波测距后，将测得的距离显示到128*64的LCD上，并附有HC-SR04用户手册。-Using ultrasonic ranging module _HC-SR04 ultrasonic distance measurement, it will display the measured distance to 128* 64 LCD, along with HC-SR04 user manual.
readFLASH-writeLCD
- 单片机利用SPI总线从flash读取图像数据并通过SPI写入液晶屏。-Microcontroller using SPI bus to read image data from the flash and write into the LCD screen via the SPI interface.
JIAOTONGDENG
- 交通灯底部开发程序,程序是通过P1口输出-Traffic lights at the bottom of the development process
nRF24L01_cx
- 主要用在智能小车温度传感避让上，实现温度引导寻迹-it can sense temperature and realised intelligent tracing
intelligent-tracing
- 智能小车寻迹程序，实现小车按指定的轨道运行，可行性强，性能稳定-it can realise intelligent tracing and make the car walk in the designed channel
accelerate-and-decelerte
- 运用c语言进行编程，以AT89C52为核心芯片，以智能小车为载体，实现小车加速和减速-it can make the intelligent car speed up and decelerate