资源列表
uio
- nrf24le1 射频无线温度传感源码 自己DIY-nrf24le1 RF wireless temperature sensing source code
AtoD
- 使用C语言开发的51单片和adc0808制作的多路温控系统-language c c51 temperature test
cewen
- 使用keil 开发 可以使用proteus 进行仿真w温度测试系统-keil uvision ds18b20
bootloader
- arduino兼容bootloader.zip-arduino compatible bootloader.zip
USB
- USB Schematic diagram for beginers. This USB Schematic with Pic Microcontroller
scomapi
- 这是通用的串口通信调试模块,可帮助需要做串口调试的人.-General debug serial communication module
test8_OLED
- 使用CC2530驱动OLED，里面已集成了部分字库，可以直接调用传感器转换后的的数据-Use CC2530 drive OLED, which has been integrated part of the font, you can call the sensor data directly after conversion
SensorDemo_DHT11
- CC2530智能农业节点，采集传感器DHT11的温湿度数据，同时把数据传给网关-CC2530 intelligent agriculture node DHT11 temperature and humidity sensors collecting data while the data is passed to the gateway
test9_AD
- CC2530芯片内部温度采集，并使用串口打印输出，可以实时观察芯片温度变化-CC2530 chip temperature acquisition and use serial printer output, temperature changes can be observed in real time chip
SOURCES
- 51单片机控制的仓库测温系统。主机为单片机，从机为分布在现场的单片机，DS18B20测温，1602显示，并通过485总线通信。-51 temperature measurement system with microprocessor controlled warehouse. Host microcontroller, the slave is distributed in the field of single-chip, DS18B20 temperature measurement, 1
OLED-DemoProgram
- 128x64的OLED模块资料以及驱动程序。-128x64 OLED modules of information as well as drivers.
PCB_Project
- 模拟电路PID调节，用运算放大器实现的PID调节，可以实现信号的自动重置和锁定。-PID regulator circuit simulation using operational amplifiers to achieve PID control, can automatically reset and lock signal.