资源列表
STEP
- 基于51单片机的计步器程序加Proteus仿真，实现记步-Plus Proteus simulation to achieve record 51 single step pedometer-based program
STC_SI4432
- 自己使用STC单片机调的一个无线发送模块和打卡器的源代码，亲测可用，按键发送固定的数组。- STC microcontroller tune yourself using a wireless transmitter module and the punch of the source code, pro-test is available, the button sends a fixed array.
STC_SI4432RX
- 无线模块ss14的接收程序，通过单片机串口发送，波特率为96-Wireless receiver module ss14 program, through the microcontroller serial transmission, 9600
006_PWM_Producer
- 基于PIC16F877A的PWM信号发生器，信号频率和占空比都可以设置-PIC16F877A can be set based on the PWM signal generator, signal frequency and duty cycle
MCU
- 基于RFID的ETC系统，自动识别车牌计算出金额-RFID-based ETC system automatically calculates the amount of license plate recognition
Embedded-C-language-source-code
- 嵌入式C语言私藏例程源码，扩展内存接口扩展等。-Possession of an embedded C language example source code
caideng
- 单片机模拟交通灯，通过51单片机，实现交通灯的交替闪烁-Single-chip simulation of traffic lights
sumaguanxianshi
- 数码管显示，基于C51单片机的4位数码管显示程序-Digital display, display program based on C51 MCU four digital tube
ledflow
- 由上至下再由下至上流水灯设计，采用C语言编程，在实物上可以成功调试-From top to bottom and then from the bottom light water design, using C language programming, debugging can be successful in the real
add--led
- 发光管演示二进制数累加，采用C语言编程，可在实物上成功调试-Light tube demo binary accumulate, using C language programming, debugging can be successful in the real
ledPbuzzer
- 流水灯+蜂鸣器设计，采用C语言编程，可在实物上成功调试-Light water+ buzzer design, using C language programming, debugging can be successful in the real
led
- 二极管与数码管同时显示，采用C语言编程，在实物上可以成功调试-Meanwhile diode with digital display, using C language programming, debugging can be successful in the real