资源列表
duoji
- 改程序可以调节舵机使之转动5个角度 0 45 90 135 180 PWM信号周期为20ms-Servos can be adjusted to change the program so that the angle of rotation 5 0 45 90 135 180 PWM signal cycle is 20ms
yaoyaobang
- LED摇摇棒显示64*16像素，外部中断方式INT0显示；取模方式：纵向取模、字节倒序-LED shook his stick 64* 16 pixel display, an external interrupt INT0 display modulo mode: longitudinal modulus, reverse-byte
10_1
- 使用并行接口方式，在12864M液晶上显示一段文字，包括汉字和英文（用总线模式）-Using the parallel interface mode, the LCD displays a text in 12864M, including Chinese characters and English (with bus mode)
74hc595
- 这是一个关于74hc595的功能级一些简单的应用。-This is a function of level of simple applications 74hc595.
24c02
- lcd1602收音机显示子程序，部分程序，仅供参考-lcd1602 radio display routines, part of the program, for reference
Two-car-balanced-program
- 两轮小车平衡程序。不错的例程，可以参考使用。-Two car balanced program
Ds1302
- DS1302时钟芯片子程序，仅供参考，如有雷同纯属巧合-DS1302 clock chip subroutine for informational purposes, any similarity is purely coincidental
DS18B20
- 温度采集DS18B20程序，适合单片机开发，以及智能小车的使用。-DS18B20 temperature acquisition procedures for microcontroller development, as well as the use of the smart car.
touch_bujin(3)
- 居于modbus通信协议的威纶通触摸屏控制源码。-Living modbus communication protocol Wei Lun through touch screen control source.
test1
- 编写Main主程序，循环调用子程LED_Display，动态点亮4位数码管，使得数码管的显示为“0123”。-Write Main main program, a subroutine call cycle LED_Display, dynamic light four digital tube, making the digital display as " 0123.
shiyan3_2
- 编写程序，令数码管的显示顺序为：0123,1230,2301,3012-Write a program to make digital tube display order: 0123,1230,2301,3012
test4
- 编写程序，使用数码管显示ADC测量得到的电压值。电压值由1位整数和1位小数构成。例如若当前AN0通道上的电压为3.6V，则数码管应显示3.6-Write a program, use the digital display voltage ADC measured. Voltage value is composed of a whole number and a decimal. For example, if the voltage on the current channel AN0 is