资源列表
Battery-charger
- 电池充电器： 使用STM8S103F3开发的蓄电池充电器，目前已投入生产使用，带工厂模式设置，过热保护，过电压检测，恒流恒压及浮冲判断-Battery charger: The battery charger is developed using STM8S103F3, at present it has been used in production, with the factory pattern set, overheat protection, overvoltage dete
software
- 二氧化锆氧气传感器的氧气含量测量程序（此程序应经应用到产品）-Procedures for the measurement of oxygen content of two zirconia oxygen sensor (this procedure shall be applied to the product)
Smart-washing-machines-based-on-SCM
- 基于单片机的智能洗衣机主控制器程序源代码-Microcontroller-based intelligent washing machine master controller program source code
Program2
- 该程序采用51单片机实现气压高度的计算，气压传感器为BMP085-The program uses 51 single chip microcomputer calculation of pressure altitude, atmospheric pressure sensor for BMP085
18b20duolucaiji
- 51单片机的四通道温度采集，1602液晶显示，自写可用。-51 single four-channel temperature acquisition, 1602 LCD, since writing is available.
source
- c51的库函数，包含有串口的，实时时钟，定时器，spi的接口函数-c51 library functions, including a serial port, real time clock, timer, spi interface functions
MP3_lib
- 一个基于STM32的mp3原码库，能够实现mp3的解码和播放-An mp3 of the original code based on the STM32 library enables mp3 decoding and playback
SDCard
- 一个基于stm32的库，用于sd卡的读写，内带有fat32的文件系统支持-Stm32-based library for sd card reader, with a fat32 file system support within the
TouchScreen
- 一个触摸屏的驱动库，用于stm32上，可以实现字体的加载，校准-A touch screen driver library for the stm32, fonts can be loaded, calibration, etc.
UCGUI_lib
- 一个ucgui的支持库，很小巧，移植于stm32,支持名种标准图形-A ucgui support library, very small, transplant stm32, were kind of standard graphics support
BLDC_1300_control-for-Ebike-code
- BLDC_1300_control for Ebike code： 使用英飞凌XMC1301单片机的基于电动自行车控制方波电机驱动程序，原理图请参照英飞凌官网提供例程，带有霍尔中断采样、电流补偿、峰值电流限制、过流过压保护等重要部分。仅供开发者设计学习参考，由此带来的商品问题将不负任何责任，谢谢！-BLDC_1300_control for Ebike code: Electric bicycle control of square wave motor driver based on
Proteus-SCM-examples
- proteus实例大全，内含程序以及仿真图-proteus Examples of Guinness, containing procedures and simulation diagram