资源列表
Photosensitive-resistance-test
- 利用adc，将光敏电阻的值数字化，并显示在数码管上-Use adc, the photosensitive resistor values digitized and displayed on a digital
Multiple-18b20-
- 利用单片机控制多个18b20，并将温度显示在1602 LCD上面-SCM control multiple 18b20, and in 1602 LCD temperature display above
nrf24l01
- 利用单片机控制NRF24L01无线模块，实现数据的无线收发-SCM control NRF24L01 wireless module, wireless data transceiver
11
- 利用定时/计数器T0从P1.0输出周期为1s的方波，让发光二极管以1HZ闪烁，设晶振频率为12MHz-The use of timer/counter T0 from P1.0 output cycle square wave 1s, so that the light-emitting diodes 1HZ blinking, set the crystal frequency is 12MHz
22
- 利用定时/计数器T1产生定时时钟,由P1口控制8个发光二极管,使8个指示灯依次一个一个闪动，闪动频率为10次/秒(8个灯依次亮一遍为一个周期)，循环-The use of timer/counter T1 timing clock generated by the P1 port to control 8 LEDs, making eight lights were flashing one by one, the flashing frequency of 10 times/sec (8 li
33
- 同时用两个定时器控制蜂鸣器发声，定时器0控制频率，定时器1控制同个频率持续的时间，间隔300ms依次输出1，10，50,100，200,400,800, 1k（hz）的方波。-Meanwhile buzzer with two timer control, timer 0 control frequency, Timer 1 control with frequency duration of 300ms intervals sequentially output 1,10,50,100,2
44
- 用定时器以间隔500MS在6位数码管上依次显示0、1、2、3….C、D、E、F，重复。-500MS interval using the timer to display 0,1,2,3 .... C, D, E, F, repeat the sequence on the six digital tube.
SPI
- microchip官网与平时收集的一些SPI的程序，希望共同进步，一起发展。-Microchip website and collect some of the SPI program at ordinary times, hope that common progress and development together.
ds3232_2452.tar
- I2c source code with ucontroller
ourdev_629832LV0808
- 基于CH376芯片的USB主机代码,只实现初始化，检测，拷贝文件！-CH376 chip USB host-based code to achieve only initialize, test, copy the file!
pipeline_light
- 基于STM32的嵌入式单片机编程，实现流水灯功能-Pipeline light based on STM32
c51
- 一些关于51单片机的学习例程，主要是基于C语言，对学习51单片机有一定的帮助-Some 51 MCU learning about routines, mainly based on the C language, is good for 51 MCU learning