资源列表
AD-LED4
- AD-LED foravrmega128
LCD1602
- LCD1602FORmega128应用,液晶数据显示-a program LCD1602 for mega128
STM8S-USBSWIM
- 采用STM32单片机制作的基于SWIM的STM8S脱机编程器。内部有STM32的固件源码，上位机程序及板子原理图和PCB图。STM32的固件源码可以在Keil uVision4编译。-STM8S offline programming based on SWIM Use STM32 microcontroller. Internal STM32 firmware source code, the PC program and board schematic and PCB map. STM32
znFAT11.21
- 最新版znFAT文件源码11.21版本SD卡读写U盘读写-znfat mcu 11.21
TFT
- 51单片机TFT彩屏程序,包含彩屏资料及多个源码例程-51 single TFT color display program, including color data and multiple source routines
Four-phase-six-wire-stepper-motor
- 四相六线步进电机控制程序源代码，通过频率控制转速-Four-phase six-wire stepper motor control program source code, by frequency control speed
ATmega128
- AVR实验 ATmega128实现流水灯效果,通过定时器1中断实现,4Mhz内部时钟,8分频,包好protues仿真程序-AVR ATmega128 achieve light water experiment results, achieved by a timer interrupt 1, 4Mhz internal clock divided by 8, wrapped protues simulation program
pic16f1823andad3984
- 基于PIC单片pic16f1823控制，a3984驱动的步进电机驱动模块程序-Based on PIC Monolithic pic16f1823 control, a3984 drive stepper motor driver module program
NT7538
- C51汇编驱动NT7538的程序，注意是汇编ASM格式的。自己测试的时候使用的。-C51 compilation driver NT7538 program, attention is a compilation ASM format. When their own tests to use.
dsplay-0-to-255
- 利用AT89S52和ADC0809采集电压，电压范围0至5V，用数码管显示0至255中任意值。-Use AT89S52 and ADC0809 collection voltage range of 0 ~ 5V, display any value from 0 to 255 with digital control.
AD-display
- 利用AT89S52和ADC0809采集电压，电压范围0到5V，再用数码管显示采集的电压值，为十进制。-Use AT89S52 and ADC0809 collection voltage range of 0 to 5V, then the voltage digital display collected, as decimal.
PCB12
- 对于驱动电路模块 驱动电机的PCB布线设计以及原理图-For the driver circuit module PCB wiring design and schematic diagram of the driven motor