资源列表
Electronic-clock
- 这是多功电子时钟的源码。 此用单片机为基础开发。 所用语言为C语言。-This is a multi-function electronic clock source. This MCU-based development. The language used for the C language.
Stepper-motor-control
- 四相八拍步进电机控制源码。 适合初学者。-Eight four-phase stepper motor control source shoot. Suitable for beginners.
UART-serial-communication
- UART通信源码。 此源码用全双工通信方式 适合初学者。-UART communication source. This source with full-duplex communication mode Suitable for beginners.
msp430G2553
- MSP430G2553 状态机结构 程序框架,定时器定时1MS-MSP430G2553 state machine architecture framework program
DS18B20
- DS18B20温度传感器C语言程序，已在项目中验证可行。-DS18B20 temperature sensor C program, available in the project has been verified.
DS1302
- 时钟芯片DS1302 源程序C代码，已在项目中验证其可行。-DS1302 clock chip C source code, has verified its feasibility in the project.
led
- 该源码实现的功能是单个LED灯指示51单片机的引脚高低电平。-The realization of the source code is the function of the height of the level indicator pin single LED 51 single chip microcomputer.
led_left-shift
- 通过51单片机来控制8个led灯循环左移，始终只有一个led灯点亮，并循环执行流水动作。-With 51 single-chip microcomputer to control 8 LED lights cycle shift left, always only one LED lights, and loop execution flow action.
Digital-tube-blanking
- 多位数码管分别显示不同数字，这种扫描显示方式称为动态扫描。在不停的变化赋值的情况下， 当高位值为0时不显示该位，即消隐，如数字 0010，实际显示为10，前2位0不显示。-Many digital show different numbers, this scanning display mode is called dynamic scanning. Changes in the assignment does not stop the case, when the high value
To-produce-the-1mS-wave
- 51单片机的定时器0产生1ms的方波,在P1.2引脚输出。-Timer 0 of 51 MCU generates 1ms wave in pin P1.2 .
serial-communication
- 打开电源，连接好串口或者usb转串口至电脑，下载该程序，打开电源,打开串口调试程序，将波特率设置为9600，无奇偶校验，晶振频率为11.0592MHz，发送和接收使用的格式相同。-Turn on the power, connect the serial port or USB to serial port to the computer, download the program, open the power supply, open the serial debugging procedu
music
- 单片机开发的按键发音，按键可出发中断，发出声音，内涵源代码和仿真图-MCU development pronunciation keys, buttons can be interrupted departure, sound, connotation source code and simulation map