资源列表
dianzishizhong
- 电子时钟的程序，有图有程序，可以使用，可以调整时间-Electronic clock program, there are pictures, you can use, you can adjust the time
baanjiandianziqin
- word文档的八按键简易电子琴，有要求 ，PCB，程序可运行，有原理图-Eight simple flower button word document, required, PCB, the program can be run, with schematics
st7920
- 液晶驱动芯片st7920源程序。msp430用，iar平涛开发-LCD driver chips st7920 source. msp430 use, iar Ping Tao development
STM32_HPI
- STM32使用IO口模拟读写DSP的HPI，完成ARM和DSP之间的通信，测试DSP型号为TMS320C6418-STM32 DSP using analog IO read the HPI, complete communications, test DSP model between the ARM and DSP TMS320C6418
sst25vf
- sst25vf32驱动程序 iar平台开发 可用于msp430-sst25vf32 driver platform can be used iar msp430
nandflash(success)
- k9f1g的msp430驱动 iar开发的 直接使用即可-k9f1g of msp430 drive
uart
- 单片机UART配置，封装成了.c文件和.h文件。包含串口发送函数与串口中断-About MCU uart configuration
control-led1-and-led2-of-msp-430
- 当sw1 和sw2 被触发时发出不同频率的LED灯闪烁- Initiates LED1 and LED2 to blink on and off at a set rate. * When SW1 is pressed, the frequency is toggled to double. * When SW1 is pressed again, the frequency is reset. * While SW2 is being pr
Lab_5_demo
- 用汇编语言控制led 发出不同频率的闪光-Issued a flash at different frequencies in assembly language control led
Lab_3_Demo_Code
- 如何用汇编语言输出数据至端口，控制端口的输入和输出-How to use assembly language output data to the port
lab11
- 在dac 上显示一个波图，刚刚输出的时候是sine 的图 开动按钮后发出不同的图像-Write a C program that creates a waveform generator. It should start by outputting a sine wave to DAC0. Each time SW1 is pressed then released, the wave form should change, first to a triangle wave, then
Lab_4_Demo_Code
- 如何使用汇编语言在msp430的单片机上调用子程序-How to use assembly language subroutine call