资源列表
EXP3_jishuqi
- P1口做输出口，接八只发光二极管，绘制仿真电路图，硬件连接表见3-1。 ①编写C51程序，采用软件延时的方式实现发光二极管的每秒闪烁。 ②编写C51程序，使8个发光二极管从右到左（上到下）逐一点亮。 ③编写C51程序，使8个发光二极管从两边到中间顺序点亮，直至全部点亮，然后从中间到两边顺序熄灭，直至全部熄灭，如此循环下去。 -P1 port as the output port, then eight light-emitting diodes, circuit simulati
EXP4_dingshiqi
- 绘制实验电路图，采用单片机内部定时/计数器T0，T0工作在计数器模式，外部事件脉冲由外部引脚引入定时/计数器T0（P3.4），即T0用来检测外部脉冲数，将其计数结果送给数码管（10个以内）显示出来。-Draw experimental circuit, SCM internal timer/counter T0, T0 works in counter mode, external event pulses generated by the introduction of an external
12864
- 用于控制LCD12864的显示 显示内容易改 可以任意编写-LCD12864 for controlling the display contents can easily change any write
CC1101
- 无线通讯芯片 CC1101 学习资料和演示程序。-Wireless communications chip CC1101 learning materials and demonstration program.
STM32_hight-feedback-control
- 基于stm32的高度反馈控制，控制超声波探头、直流电机-Stm32 feedback control based on the height, the control of the ultrasonic probe, DC
main
- 简单测铂电阻的芯片Max31865 只需要用SPI口-Max31865 using
CO_Control
- 16路巡检 及4-20ma 采集显示源程序-using 8051F005
max31855
- MAX31855应用程序 只用到SPI口-using MAX31855
77E58
- 此源代码是在汇编语言基础上编译的有关77E58串口调试的程序，内容适用易懂。-This source code is compiled on the basis of the assembler language about 77E58 serial debugging, content applicable and easy to understand.
MBUS
- 利用MBUS总线将雨量传感器采集到的降雨量数据传输到监控计算机上。-Use MBUS bus transfers rain sensor to the rainfall data to the monitoring computer.
RS485
- RS485监控分站将煤矿井下传感器采集到的数据处理后传输到地面监控分站。-RS485 data monitoring and control stations for underground mine sensor to be processed and then transmitted to the ground control center
MBUS1
- MBUS智能传感器是利用MBUS总线将井下传感器采集到的数据实时传输到地面监控中心。-MBUS MBUS bus is the use of smart sensors downhole sensor to the real-time data transmission to the ground control center.