资源列表
TM1618_Driver
- 公司应用过无bug，测试稳定读懂代码已封装好友TM1618.C文件和TM1618.H文件-The company had no application bug, test code is encapsulated stable read and TM1618.H friends TM1618.C file file
NTC_T_mcu_code
- NTC负温度系数ADC采集对应表代码，5V表和3V数据准确，误差在+1到-1之间，数据稳定。文件有NTC.C和NTC.H文件。-NTC negative temperature coefficient ADC codes correspond collection, 5V and 3V table data is accurate, error between+1 and-1, the data is stable. File has NTC.C and NTC.H file.
NTC_Filter_code
- NTC_Filter_code是基于温度的一个平滑滤波算法，非常实用，在项目中经常会用到。-NTC_Filter_code is a smoothing algorithm based on temperature and very practical, often used in the project.
HAL_drive_SHT1X
- 文件有HAL_drive_SHT1X.c和HAL_drive_SHT1X.h测试通过温湿度采集准确。-File has HAL_drive_SHT1X.c and HAL_drive_SHT1X.h tested collect accurate temperature and humidity.
dz60
- freescale dz60 can source
LCD
- STM8 LCD的相关程序，开发环境为IAR，C语言-STM8 LCD IAR C language
STM32_COM_queue
- 将串口的发送缓冲区建立成一个环形的缓冲区，在这个环形缓冲区内，通过头指针来定位空白区 和数据区-The establishment of the serial transmit buffer into a ring buffer in this ring buffer pointer to locate the blank through the head area and the data area
The-End
- 基于STM32F103RB（正点）所做的幅频特性显示器。采用AD9851产生1VPP信号，经过滤波器，再通过AD637变为直流信号，最后将信号显示在液晶屏上。-STM32F103RB based on amplitude-frequency characteristics (punctuality) made displays. 1VPP signal generated using the AD9851, through the filter, then through AD637 into
CRC16_code
- CRC16校验代码编写规范，函数已经编写好只需调用即可。-CRC16 verify coding practices, simply call the function has been written to.
malloc_code
- 单片机内部实现malloc函数，方便移植使用任何单片机，代码规范。-Internal MCU malloc function to facilitate transplant using any microcontroller code specifications.
os_mutex_sem
- 单片机实现信号量功能函数，方便移植使用任何单片机，代码规范。-MCU semaphore performance function, easily ported to use any microcontroller code specifications.
pcm_13A_code
- 实现PCM功能函数，方便移植使用任何单片机，代码规范,适用于对数据精度要求不高的数据才可压缩。-PCM achieve performance function, easily ported to use any microcontroller code specifications for data accuracy is not required before the data compression.