资源列表
UART1
- 本程序讲述了C8051F020的串口配置，为初学者提供了参考。-gja s s j sn bm m,smn ndmn
TimingRelay
- 51单片机程序，共阳极数码管，通过继电器控制电灯，电热水器等电器开关。单片机启动后，键盘1进行小时十位设置，键盘2进行小时个位设置，键盘3进行分钟十位设置，键盘4进行分钟个位设置，键盘5进行继电器初始状态设置，键盘6启动计时，数码管进行倒计时显示，到时间后，继电器进行取反操作。 可以用于延时继电器开，或延时继电器关。-51MCU program, control lamp,water heater by relay. After the program start, key 1 set tens
Main
- 51单片机与触摸屏通过MODBUS协议连接的源程序代码，-51 and the touch screen through the source code MODBUS protocol connection,
DY
- 电源适配器程序，自带电池高级适配器，自带充放电保护-The program comes with power adapter, battery charge and discharge protection with advanced adapter.
SDADC
- stm32f373 sdadc测试源代码，经测试可用，欢迎大家下载测试-sdadc test is ok
ucosII
- stm32f373 ucosii 操作系统移植，测试可用，大家用的到的都可以-stm32f373 ucosii test is good
Program_V1_0
- PIC18F2680的TMR0，TMR1初始化，INT0初始化，低级高级中断服务程序，IO初始化-PIC18F2680 TMR0, TMR1 initialization, INT0 initialization, low-level high-level interrupt service program, initialization of IO
ProtocolTest_Program_V1_3
- dsPIC30F6014A开发的，实现485通信和TM1640驱动数码管显示程序-The development of dsPIC30F6014A, the realization of the 485 communications and TM1640 drive digital tube display program
GPIO_LED_Key
- STM32F107开发的，实现GPIO初始化和控制输出-STM32F107 development, the realization of GPIO initialization and control output
Usart
- STM32F107开发的，串口初始化，串口通信例程-The development of STM32F107 serial communication routines
UART
- C8051F020串口通信程序，波特率9600，全双工通信。并且包含了AD功能。-C8051F020 serial communication procedures, 9600 baud rate, full duplex communication. And contains the AD function.
18B20
- C8051F020+DS18B20，完成单总线测试温度的功能。通过7929对LED数码管进行显示-C8051F020+DS18B20 single bus temperature test functions. By 7929 LED digital tube display