资源列表
MB91F59x_CAN_Bootloader_V1.1_53B_DM
- 富士通单片机底层驱动，关于MB91530的启动代码，可以作为参考，来写自己的bootloader.-Fujitsu microcontroller bottom drive, MB91530 on the boot code, can be used as a reference to write their own bootloader.
RC_A7159_x0_470-510MHz-Band-Ref
- 获得IPC的信息，可以根据IP地址决定是否增加设备-Based on the official A7159 wireless transmission code routines
ultrasonic
- 本程序是在STM32F103ZET6单片机的定时器输入捕获功能实现超声波模块的调试-This program is an input capture function in timer STM32F103ZET6 single-chip debug module to achieve ultrasonic
SG90
- 程序是基于STM32F103ZET6实现舵机调试，源码可以实现用户给指定角度，然后舵机转到相应角度-Procedure is based servo STM32F103ZET6 achieve debugging, source code may be implemented for the user to specify the angle, and steering angle corresponding to
TIM_NVIC
- 基于STM32F103ZET6实现定时器中断实现定时器中断功能-STM32F103ZET6 achieve timer interrupt based timer interrupt function to achieve
SPI_sent_rec
- 基于STM32F103ZET6单片机实现SPI通讯协议的接收以及发送数据-Receiving and transmitting data STM32F103ZET6 MCU SPI communication protocol based on
pwm_check
- 基于STM32ZET6单片机实现定时器的pwm输出功能并连接小灯实现呼吸灯功能-Based STM32ZET6 MCU timer pwm output and connect small light lamp function to achieve respiratory
MPU6050_check
- 在stm32单片机上利用IIC通讯协议实现mpu6050陀螺仪工作，利用上位机观察陀螺仪的位置情况-IIC communication protocol using the MCU mpu6050 stm32 gyroscope work, using the position where the PC observed gyroscope
yaoyaobangchengxu
- 基于stc89s52写的摇摇棒程序，通过led的动态显示出各种图案-Based on stc89s52 write shake stick procedures, led by the dynamic display of a variety of patterns
I2C_EEPROM
- 这是一个STM32的例程，实现I2C通讯，I2C主设备先写入EEPROM数据再读取。-This is a STM32 routines to achieve I2C communications, I2C main device to write EEPROM data read.
PLC
- 自制plc 源码程序。 有51单片机制作plc 源码程序+源流图 +sch+pcb图 还有国外开发人员编写的 avr单片机制作plc程序 +原理图+sch+pcb图-Homemade plc source code procedures. There are 51 single-chip production plc source code+ source map+ sch+ pcb map There are foreign developers to prepare the avr
xunjixiaoche(hongwaichuangan)
- 寻迹小车（红外传感的实现），基于keil4开发环境-Tracing car ( realization of infrared sensor ), based on keil4 development environment