资源列表
光电编码器_12864
- 光电增量式编码器，通过旋转 用12864显示角度，可以正反侧(Photoelectric incremental encoder, through rotation, with 12864 display angle, can be positive and negative side)
COMPART
- modbus-rtu协议从机代码。功能码01,03,05,16.(MODBUS-RTU protocol slave code. Function code 01,03,05,16.)
jidianqi
- 一个简单用单片机实现继电器控制并具有计数功能，所附的原理图和程序并不配套，但原理基本一致；两个程序，一个是参考程序，另一个是自己编的程序(A simple microcontroller can control the relay and have counting function. The attached schematic diagram and program are not matched, but the principle is basically the same. Two p
32机械臂履带车_记忆调试阶段
- 通过手机蓝牙控制6自由度机械臂，无须单独控制每个角度实现联动控制(Through the mobile phone Bluetooth control 6 degrees of freedom mechanical arm, no need to control each angle to realize the linkage control)
STM32F4
- STM32F4工程模板,标准库1.8.0(STM32F4 porject templates)
STM8实现按键LED程序
- 实现stm8的IO口之间的互动，电路板上高低电平的转换，体现为按键和LED灯。 按下按键，灯亮。并且有流水灯功能。(Realize the interaction between the IO ports of stm8, the conversion of the high and low level on the circuit board, reflected as the key and the LED light. Press the button, the light is on
Project_RTI
- s12xep100 RTI模块简单的设置及波形生成。(s12xep100 RTI for pwm)
用单片机PWM实现DA
- 如果在单片机控制的仪表里用PWM方式完成D/A输出，将会使成本降低到12位D/A芯片的十分之一左右。我们在S系列流量仪表中采用了这种方式，使用效果非常理想。下面介绍一下PWM方式D/A的构成原理。(If in the microcontroller control instrument, using PWM way to complete the D/A output, will reduce the cost to 12 bit D/A chip about 1/10. We have ado
延时程序
- 延时程序，自己整理的一个延时程序集合，可以方便调用直接使用不需要计算(Delay procedures, finishing a collection of their own delay procedures, you can easily call the direct use, do not need to calculate)
实验13 TFTLCD显示实验
- LCD屏幕显示程序,测试LCD屏幕正常显示的程序(LCD screen display program, test the normal display of LCD screen program)
s12xep100 PWM
- xep100的PWM模块的实例，比较通用，可直接配置频率/占空比。(s12xep100 pwm,the frequency/proportion can be directly configured.)
TEST
- 4通道4-20mA模拟量采集板通过RS485总线发送采集数据给PC机(The 4 channel 4-20mA analog acquisition board transmits data to the PC through the RS485 bus)