资源列表
buck_cc
- MCU实现恒压输出,51内核单片机，双路PWM。(mcu buck CV OCP OVP PWM ADC)
CH341A编程器软件
- x98 air 3g bios 刷新方法和注意事项(x98 air 3g bios update)
ft245
- 基于STM32F407的FT245R读写时序(FT245R reading and writing sequence based on STM32F407)
DS18b20
- 数字温度传感器DS18b20试验，DS11820读、写，温度测试(DS18b20 test of digital temperature sensor)
寻线
- 实现AVR单片机控制的小车的寻线行驶功能(Realizing the line seeking function of the car)
微型四轴原理图和PCB源文件
- 四轴pcb身是围绕CPU组织起来的。CPU的任务是读取物理传感器（陀螺仪和加速度计）的测量结果，给出控制信号控制电机，让直升机保持稳定。通过 一个控制反馈回路，CPU每秒能够对电机发送250次调节转速的指令。无线通信的带宽需求很低，仅仅需要发送操作命令和接受遥测数据。CPU上运行的程序 可以通过无线通信更新.(This paper applies boundary scan, which usually used in PCB test, on the simple four-axis-link
ADF4002_51驱动
- 实现ADF4002鉴相器的51单片机驱动代码，可设置倍频及分频倍数(The 51 single chip driver code of the ADF4002 phase detector can be realized, and the frequency doubling and frequency division multiple can be set)
div码表
- 可以通过keil形成hex文件，烧录到单片机上。通过按键的控制形成码表的计数，储存，复读，清零。(The hex files can be formed by keil, which can be burned to a single chip. The control of the keypad forms the number of the code table, storing, rereading, and clearing.)
TIM4
- STM8S003F3P6定时器，定时时间为1ms(STM8S003F3P6 timer, timing time is 1ms)
arduino-DHT-master
- arduino buledert good condition for every thing
f330起飞代码
- 用于四轴飞行时的起飞代码，内容不是很多，也不是太好(The takeoff code for four axis flight is not a lot, and it's not too good.)
MiniPowerMeter(Qt)
- 电量计，作为负载耗电的测试和查看。完全开源。(The electric meter, as the test and view of the load power consumption. Completely open source.)