资源列表
li-sensor - 3.28
- 折盒器控制程序，同时控制六个步进电机同步运动，以及与传感器信号间的配合。(The control program of box folding device controls the synchronous movement of six stepper motors and the cooperation with sensor signals.)
SPI通信
- 利用单片机实现温湿度采集和SPI进行通信，结果能够实现(Using single chip microcomputer to realize temperature and humidity acquisition)
1pwm
- 该程序能够输出PWM方波，驱动直流电机转动。利用高低电平输出，控制直流电机转向。(The program can output PWM square wave and drive DC motor to rotate. The steering of DC motor is controlled by high and low level output.)
2capture
- 该程序能够检测编码器输出的方波，检测直流电机转速。从而控制控制直流电机转速,实现PID调节。(The program can detect the encoder output Fang Bo and detect the DC motor speed. So as to control the DC motor speed and achieve PID adjustment.)
3oled
- 该程序能够检测编码器输出的方波，检测直流电机转速。从而控制控制直流电机转速,实现PID调节。将所测得的数据通过OLED显示,以实现检测.(The program can detect the encoder output Fang Bo and detect the DC motor speed. So as to control the DC motor speed and achieve PID adjustment. The measured data are displayed thro
01、泥人STM32mini-LED灯实验
- 基础功能，入门开发。I/O口的驱动基本认识。(Development of basic function)
1278-smt
- 射频通信lora通信模块相应资料，可以使用1278进行通信无线抄表(Radio frequency communication)
wwork
- 利用PSCAD建立了一个电气13节点系统，可计算13节点系统潮流等。(An electrical 13-node system was established using PSCAD to calculate 13-node system currents.)
36456720STM32-SD--Operation-
- SD卡的读写操作。使用串口助手进行调试，能够发送字符串命令，能够读取SD卡中的内容以及大小和剩余空间。(The read and write operation of the SD card.)
MPU6050+OLED
- STM32控制MPU6050输出三轴加速度计与三轴陀螺仪原始数据，并用OLED显示传感器的电压值。(STM32 controls MPU6050, outputs three axis accelerometer and three axis gyroscope raw data, and displays voltage value of sensor with OLED.)
NAND FLASH +STM32
- stm32控制实现与非型FLASH的存储。内部利用循环数组缓存，存储递增数。(The STM32 control implementation and the storage of the non - type FLASH. Internally, we use cyclic array buffer to store increasing number.)
ra8875驱动
- TFT控制器8875驱动，亲测有效。。。。(TFT controller 8875 drive, pro test effective...)