资源列表
C51_16×16
- 51单片机16×16点阵滚动显示，并使用Proteus仿真
m430
- 单片机MSP430源代码示例上传分享，仅供参考-MSP430 microcontroller source code examples Upload share, for information purposes only
_C51_4
- 51单片机4*4键盘识别，已通过Keil 8.2检查-51 4 * 4 keyboard identification, has passed inspection Keil 8.2
_Proteus_delay
- 51单片机继电器仿真，内包含keil程序，Protes仿真-51 microcontroller relay simulation, which includes keil procedures, Protes Simulation
My_OS
- 彭光红先生的《小容量单片机系统的C语言程序结构》源代码-Fonte's "small-capacity SCM System C language program structure" source code
_Key
- 矩阵式键盘的控制，已通过Keil检测，包含四个源文件-matrix keyboard control, has passed Keil detection, the source document contains 4
_I2C
- 51单片机IIC总线试验包，已通过KEIL检测，并有Proteus仿真-51 microcontroller IIC bus test kits have been approved, KEIL detection, simulation and Proteus
jisuqi15
- 计数器程式 计数器程式 -program counter counter programming formula program counter counter counter program program
The.simple.number.controls.direct.current.power.su
- 本系统是以凌阳SPCE061A单片机为核心控制器，具有电流可预置、可步进调整、输出的电流信号和预置的电流信号可同时显示的数控直流电流源。系统主要包括：凌阳SPCE061A精简开发板、键盘与显示电路、压控恒流源电路、校正电路、电源电路等。系统中通过键盘按键对电流值进行预置，凌阳SPCE061A单片机送出相应的数字信号，经过D/A转换、信号放大、电平转换、压控恒流源，再输出所需电流；实际输出的电流经过精密电阻变成取样电压信号，经高输入阻抗放大器、A/D转换器，将信号反馈到凌阳SPCE061A单片机中
show_ads
- 8051单片机C语言控制与应用nand flash启动u-boot源码-8051 C language and application control nand flash activated u-boot FOSS
TL1763_16bit
- 该C程序详细介绍了基于TL1763控制器的LCD初始化及显示源代码.-the C program in detail based on the TL1763 initialization LCD controller and display the source code.
test2129
- DS18B20 与STC89C58RD＋系列单片机的串口通讯协议-DS18B20 and STC89C58RD + Series MCU serial communication protocol