资源列表
lamu
- 用AT89S51单片机的P0.0/AD0－P0.7/AD7端口接数码管的a－h端，8位数码管的S1－S8通过74LS138译码器的Y0－Y7来控制选通每个数码管的位选端。AT89S51单片机的P1.0－P1.2控制74LS138的A，B，C端子。在8位数码管上从右向左循环显示“12345678”。能够比较平滑地看到拉幕的效果。-P0.0/AD0-P0.7/AD7 with AT89S51 microcontroller port connected to a-h digital side, 8-
guanggaodeng
- 做单一灯的左移右移，硬件电路如图4.4.1所示，八个发光二极管L1－L8分别接在单片机的P1.0－P1.7接口上，输出“0”时，发光二极管亮，开始时P1.0→P1.1→P1.2→P1.3→┅→P1.7→P1.6→┅→P1.0亮，重复循环。 -A single light left to do right, the hardware circuit as shown in Figure 4.4.1, the eight light-emitting diodes L1-L8 are connect
MCS-51tongxin
- 讲的是MCS-51串行通信及其应用 的学习资料-Talking about the MCS-51 serial communication and application of learning materials
1
- 本实验的实现功能：LED闪烁.适用于zigbee开发板。-In this study, the implementation features: LED flashes. For zigbee development board.
F34x_Blinky
- This program flashes the P2.2 green LED on the C8051F34x target board
F340_x
- This program flashes the P2.2 green LED on the C8051F34x target board
15years-PCB-Layout-Guide
- 台湾硬件工程师15年layout资料，详细分析走线需要注意的问题及解决方法。-Taiwan' s information hardware layout engineer for 15 years, detailed analysis of the alignment problems that need attention and solutions.
virtualhome
- This explains about a virtual home that can be controlled by our thoughts
TAIWAN-_PICC
- TAIWAN _PICC.rar 很好的PICC教学文章，-TAIWAN _PICC.rar good teaching PICC article
IAP88_V1.0
- 这是一个简单的ATMega88上的Bootloader，通过按键或者EEPROM中的值来控制是否更新Firmware。-This is a simple bootloader on ATMega88,which is controlled by the button or the value of the EEPROM for the firmware updating.
1
- 详细的介绍了飞思卡尔芯片的主要资料 对于想学习飞思卡尔的人来说十分有帮助-Detailed introduces the freescale chip the main material for people who want to learn freescale is very helpful
CodeWarrior
- 详细的介绍了codeWarrior软件的使用过程 对于想学习飞思卡尔单片机 及嵌入式的人来说十分重要-Detailed introduces the codeWarrior the use of the software process to want to learn freescale microcontroller and embedded person is very important