资源列表
signal_input
- MT8870 DTMF信号输入测试-MT8870 DTMF signal input test
EUSART-RX
- EUSART RX 程序，数码管显示其通信状态-The EUSART RX program, the digital display communication status
ADaLCD
- PCF8591芯片的AD转换，转换完以后用LCD1602显示获取的电压值-The PCF8591 chip AD converter, to obtain the value of the voltage switch is completed LCD1602 display. . .
main
- F2812 标准FFT算法,128点,256点,512点,1024点FFT算法,具体做法为将库含数FFT.LIB加入的目标项目,加入对应的C含数和头文件,特别注意的FFT算法缓冲去一定要存放在0X8000H中的内部缓冲区中!!!切记,本人调试时就走了很多弯路啊-F2812 standard FFT algorithm, 128 points, 256 points, 512 points, 1024 points FFT algorithm, and the specific practices
VB-and-SCM
- 本文详细介绍了VB和单片机之间进行通信的过程。为了确保通信的可靠性，特别设计了一种以单片机为主控机的通信协议，并对其性能进行了初步探讨-This paper describes the process of communication between VB and SCM. In order to ensure the reliability of communication, specially designed a single-chip communication protocols fo
1602-yaokong-1602-ASM
- 遥控1602液晶显示 汇编-Remote 1602 LCD assembly
guangmingC
- 光敏和热敏电阻实验-Photosensitive and thermal resistance experiment
USB-Computer00-Code
- USB Computer00-Code.zip 基于51单片机，《圈圈教你学USB》中的全部源代码，USB芯片为PDIUSBD12.-The USB Computer00-Code.zip based on 51 single-chip, " circle to teach you to learn the USB in full source code, USB chip for the PDIUSBD12.
01_GPIO
- CORTEX-M0 单片机LPC1343的GPIO例程-CORTEX-M0 microcontroller LPC1343 GPIO routines
51zhengxian
- 51单片机，利用正弦表发正弦波程序，本例幅值最大2.5v，频率5HZ，另附正弦表程序，可以根据需要更改幅值和频率-51 SCM, sine table made sine wave program, in this case the amplitude of the largest 2.5v frequency 5HZ attached sine table program, you can change the amplitude and frequency ...
4X4KeyScanaSegDisplay
- 4*4矩阵键盘扫描程序，只是个函数，需要放进C51程序主函数中调用。-keyboard scan
mega48_jiema
- 红外解码，红外遥控器，基于META48单片机，开发环境ICCAVR-lcd driver