资源列表
uart_rs232
- 基于MSP430F5438A的RS232串口通讯程序-RS232 serial communication program based on MSP430F5438A
4channel_AD_Multi_convertion
- 基于msp430F5438A的4通道8次AD转换程序，可参考调用-Based on the 4-channel 8 msp430F5438A AD conversion process, refer to the call
AD-value-print
- 基于msp430F5438A 的AD值打印到串口，方便程序调试-The AD value based on msp430F5438A print to the serial port, to facilitate debugging
CH452--drivers
- 包含了CH452的驱动例程，已经调试通过。里面有两个例程，一个是51的(keil)，一个是430G2452的(CCS)-Contains the CH452 driver routines have been through debugging. There are two routines, one is 51 (the keil), one the 430G2452 of (CCS)
DS18B20
- 开发环境：EWARM mcu:STM32 温度传感器DS18B20的温度实时显示（开机画面） 硬件环境： TFT:PE0-PE15--->DB0-DB15 PD7->CS PD8->RS PD9->WR PD10->RD PD11->RESET DS18B20：DQ-->PD4 功能： 显示开机画面，且环境温度的实时显示-Temperature sensor DS18B20 temperature real-time disp
ADS7846
- 跟踪触摸笔迹，触摸控芯片（ADS7846），MCU为stm32，振南电子 触摸屏上画图演示程序 如欲引用，敬请署名并告知， 严禁随意用于商业目的，违者必究，后果自负。-Tracking the touch of handwriting, touch control chip (ADS7846), MCU stm32 electronic touch screen on Zhen Nan Paint Demonstration Program For reference, please si
nRF2401A-transportation
- TX为发送程序不断发送TxBuf里的数据，RX为接收程序当接收到数据之后就把当前数据从串口发出。波特率 无奇偶校检，9600，N，1。 程序已编译通过，可直接下载.hex文件到模块上即可实现程序功能。-TX data is send the program continue to send TxBuf the RX when the received data to receive the program put the current data sent from serial por
nRF2401A_RX_TX
- 基本成功。 收到数据时，能点亮一个led。 单片机 STC12C5260S2 1T 延时用的是单片机小精灵 stc1T 模式编写 使用查询法-Essential for the success. Data is received, you can light up an LED. SCM STC12C5260S2 1T delay with the MCU elf stc1T mode to write using the query method
ADC_12864
- MSP430 AD采集程序 并用12864显示-The MSP430 AD collection procedures and 12864 show
main
- 单片机控制多媒体芯片，对芯片机型寄存器配置-Microcontroller to control the multimedia chip
User
- 串口调试信息打印程序，输出调试信息到串口-Serial debug information printing program output debugging information to the serial port
main
- mcu控制mosfet组成的升压电路程序，驱动el-mcu control mosfet boost circuit, driver el