资源列表
wave
- 可以实现3种不同的波形，可以根据需要添加-Can realize three different waveform, can according to need to add
key-(1)
- 通过T2计时器来对按键定期扫描，获得键值，执行相应程序，可以去抖的-Through the T2 timer to key regular scanning, get key value, implement the corresponding procedures, can go to the shaking
SPI
- HT66F40對HT93LC46進行SPI通信，對其進行讀寫數據的操作-HT66F40 on HT93LC46 SPI communication, read and write data operation
nRF24L01(send-_receive)
- nRF24L01无线通信发送与接收程序,已测试通过.-nRF24L01 wireless communications to send and receive procedures have been tested.
kekong_-feibit_18b20
- 基于zigbee技术的ds18b20的采集程序。-Based on zigbee the technology ds18b20 the acquisition program.
CC2530IOTest
- 无线单片机cc2530控制led灯闪的程序。-The wireless microcontroller cc2530 Control led lights flash program .
CC2530T1Test
- cc2530利用定时器控制灯闪烁的程序。-cc2530 timer to control lights flashing program .
TCS3200
- TCS3200颜色识别传感器C51例程，使用定时器计算输出的频率值，返回RGB值。-C51 routines of the TCS3200 color recognition sensor, timer output frequency calculated value, returns the RGB values.
11_ZStack-CC2530-2.3.0-1.4.0_
- 基于zstack的协议栈开发，传感器采集数据，然后通过路由器上传到协调器节点，最终在pc机上显示。-Zstack the protocol stack development , sensor data collection, and then uploaded through the router to the coordinator node , the final show on the pc .
mimasuo
- 用51单片机控制的电子密码锁，在1602液晶屏上显示。-51 SCM control of electronic locks, in 1602 LCD screen on the display.
dianzicheng
- 电子秤protues仿真+程序设计，程序已经经过调试。-Simulation using electronic scales protues+ programming. .
Serial-remote-control-decoder
- 遥控解码通过电脑串口显示,此程序是自己参照别人的写的-****************** Remote control decoder through the computer serial display