资源列表
16
- 单片机16键的电子琴的设计程序，为单片机爱好者参考-单片机 16键电子琴的驱动
24c02
- 24c02存储芯片的驱动，供单片机学习者参考，本人经常用的-24c02
testprogram
- 用发光二极管可测试最小系统单片机的焊接是否正确。如果焊接正确则p0，p1,p2.p3口的灯会闪烁-LEDs can be tested using the smallest single chip welding system is correct. If the weld is properly p0, p1, p2.p3 port LED will flash
am_dds
- 基于430的调幅信号源程序。利用430控制两路ad9851来产生载波信号和调制信号-Based on 430 AM signal source. Ad9851 by 430 to generate two-way control of the carrier signal and modulation signal
gdLCD
- 运用单片机实现发光二极管左右跑马灯。灯的公共端接高电平。限流电阻330左右-About the use of single chip LED Marquee. Termination of public high light. Limiting resistor of about 330
Config_MMC
- Config_MMC.bas - (BASCOM) file for including into main program-Config_MMC.bas - (BASCOM) file for including into main program
single
- pc计算机与单片机串口通信源程序 包含上位机和下位机的程序 -PC computer and single-chip microcomputer serial communication source program
AD9856-EPM240-MSP430F149-ADS825
- AD9856+EPM240+MSP430F149+ADS825 is an verygood drefence design for dds-AD9856+ EPM240+ MSP430F149+ ADS825 is an verygood drefence design for dds
picusbnut
- utilizando PIC e Visual c# com a comunicacao usb
exp3
- 花样流水灯：8个发光二极管D1~D8分别接在单片机P0.0-P0.7端口上，一个开关接在P3.0上。要求输出端口输出“0”时，发光二极管亮。开关闭合时，开始按P0.0+P0.7、P0.1+P0.6、P0.2+P0.5、P0.3+P0.4的顺序依次点亮LED，再按P0.3+P0.4、P0.2+P0.5、P0.1+P0.6、P0.0+P0.7的顺序点亮LED，重复循环。开关断开时，立刻停止点亮指示灯。-Mood Light water: 8 LEDs D1 ~ D8, respectively, c
SDCardProjectwithPic
- SD Card Project with PIC
CtrlClient
- STC89C51驱动L298并接受串口通讯（协议）KEIL C程序-STC89C51 drive L298, and accept the serial communication (protocol)