资源列表
ds1302
- 基于ds1302时钟芯片的驱动程序，可实现年月日时分秒的输出-Ds1302 clock chip driver, date, minutes and seconds output
LCD12863-display-character-
- 使用中文液晶LCD（12864）显示一些必要的信息-Using Chinese LCD LCD (12864) show some of the necessary information
ZLG7290-test-temperature
- 用ZLG7290芯片测温度，同时利用中文液晶LCD12864加以显示。-With the chip ZLG7290 measured temperature, while taking advantage of the Chinese LCD LCD12864 be display.
sms0408d
- sms0408d四位数码显示 液晶显示 直接使用 不用调试-sms0408d four digital display LCD directly without debugging
6MSP430-sends-P-state-to-PC
- 透过串口发送给电脑p1口的状态，格式：aXXXXXXXX.对应的是P1.01234567，9600波特率-State sent to the computer through the serial port p1 mouth, Format: aXXXXXXXX corresponding P1.01234567, 9600 baud rate
8MSP430F149-sends-data-to-PC
- 使用MSP430F149芯片，透过串口给电脑发送数据，波特率9600,8数据，无校验，。发送的数据先是 MCU sends 0~127 to PC and the\\n screen will display their corresponding\\n ASCII code as follows:然后是01234567890123456789abcdefgh......,每发送一个数据回车一次-MSP430F149 chip to send data to the computer throu
51PHD7279
- 基于51单片机和HD7279的计算器设计-51 And HD7279-based calculator design
DS1302
- DS1302在MSP430F149上的驱动程序，更改ds1302.h里面的端口宏定义就可以了。时间证明很好用！ -DS1302 driver on the MSP430F149 port macro definition change ds1302.h inside. Time has proved easy to use!
DDS_AD9850
- DDS AD9850在MSP430F149上的驱动程序，电子设计竞赛必用模块。包括并行和串行两种驱动，更改相关端口宏定义即可使用。 -The DDS AD9850 driver on the MSP430F149 Electronic Design Contest will use the module. Include both parallel and serial drive, change the relevant port macro definitions can be used.
LCD
- This code is based on 51 single-chip platform, design and color screen display program, for beginners a certain reference
Stepping-motor
- 此代码是基于51单片机的平台上，设计的控制步进电机程序，对初学者有一定的借鉴意义-This code is based on 51 single-chip platform, control the stepper motor design program, certain referential significance for beginners
TaxiJijiaqi
- 基于瑞萨单片机设计的出租车计价器，已经验证成功，可以直接使用-Taximeter based on Renesas MCU design, validation is successful, can be used directly