资源列表
MCU_led
- 单片机系统上LED灯与按键复用端口扫描电路改进-LED lights and buttons reuse port scan circuit to improve SCM system
UART_LPC1768
- LPC1768下的一个串口程序。此程序可以嵌入到其他工程中用于调试。源码为keil工程。-LPC1768 under a serial program. This program can be used for debugging embedded into other projects. The source code for keil project.
RTC_LPC1768
- LPC1768芯片的RCT程序。程序完整实现了RTC功能，源码为keil工程。-Program LPC1768 chip RCT. The program complete RTC functions, source code for keil project.
DCsimulat
- pscad的主流仿真 建立了主流输电系统 网络电压380V 频率50Hz-the simulation of DC power system based on pscad
delay-time
- 飞思卡尔16位单片机控制跑马灯程序，软件延时和硬件延时，适合初学者使用-Freescale 16-bit microcontroller control Marquee program software delay and delay hardware, suitable for beginners to use
set-timer
- 飞思卡尔16位单片机跑马灯程序，定时器延时，已调试，适合初学者-Freescale 16-bit microcontroller Marquee program, timer delay has debugging for beginners
test3
- 飞思卡尔16位单片机加壁障传感器控制加壁障传感器程序，加蜂鸣器-Freescale 16-bit microcontroller plus barrier sensor control sensor program, plus plus barrier buzzer
set-2s
- 飞思卡尔16位单片机延时2s控制跑马灯程序，适合初学者使用，已调试-Freescale 16-bit single-chip delay 2s control Marquee program, suitable for beginners to use, debug
test2
- 飞思卡尔16位单片机控制红外壁障传感器程序，已调试，适合初学者-Freescale 16-bit single-chip control IR barrier sensor program, debugging, suitable for beginners
HR6P59HL
- 主要介绍海尔单片机HR6P59HL的datasheet，应用笔记，以及部分程序。由于该单片机为OTP而且使用较少。供大家分享下。-Introduces the Haier the microcontroller HR6P59HL the datasheet, application notes, as well as part of the program. Since the MCU OTP and use less. Share with
I2CPds1307Peeprom
- 基于I2C通信的ds1307芯片以及EEPROM模块的集合-Based on a collection of the ds1307 chip EEPROM I2C communication module
XS128_demo_code
- 自己买的飞思卡尔MC9S12XS128MMA单片机开发板送的各个模块程序程序，对于学习XS128单片机很有帮助。-Buy their own the Freescale MC9S12XS128MMA microcontroller development board to send the various modules of the program procedures, for learning XS128 microcontroller helpful.