资源列表
15-MQX-gas-smoke-sensor-test-program
- 15 MQX 气体烟雾传感器测试程序设计，c语言环境开发，并有注释文字-15-MQX gas smoke sensor test program design, C language development environment, and the comment text
ch375
- usb通信接口芯片程序，本程序给出了ch375作为主机和辅机的代码。-USB communication interface chip program, the program gives CH375 as the code of the main and auxiliary engines.
I2C_E2PROM
- 使用c8051F040单片机通过IIC总线读写E2PROM程序 -The E2PROM program C8051F040 microcontroller through the IIC bus read and write
led1-5
- 按键扫描，实现LED灯ON/OFF。第一次按下按键时，LED灯被点亮；第二次按时，LED灭-failed to translate
1mS
- 实现LED灯1MS闪烁效果， 实现LED灯1MS闪烁效果，-failed to translate
remote
- 遥控器信号解析代码。三星遥控器-get remote message
a
- 关于51单片机的步进电机模块的c语言的编程例子（可实现）-failed to translate
liushuideng
- 51单片机+8255，流水灯设计,实现流水显示-Singlechip+8255 water lamp design
PWM
- 产生PWM信号， 产生PWM信号， -failed to translate
110616.mcp_5_backup
- 灌胶机程序 基于ARM9的灌胶机 包含注塑机测量位移和压力传感器的形变量-Glue machine program arm9-based glue machine consists of injection molding machine measurement of displacement and pressure sensors
AD9850(9851)
- AD9850（AD9851）实现DDS基于单片机的函数信号发生器设计的源代码-failed to translate
msp430
- 基于msp430格林注塑机程序 包含4个压力位移传感器 开发软件IAR-Based on msp430 green plastic injection machine program consists of four pressure displacement sensor developed software IAR