资源列表
ADC
- 基于MSP4301系列单片机的内部ADC驱动程序-Based MSP4301 series microcontroller' s internal ADC drivers
ADS1115
- MSP4301系列单片机驱动ADS1115并在5110液晶上显示结果-MSP4301 Series 5110 single-chip driver ADS1115 and displays the results on the LCD
PWM
- MSP4301系列单片机内部PWM控制程序-MSP4301 Series MCU internal PWM control procedures
SPI
- MSP430F1系列单片机内部SPI驱动程序-MSP430F1 MCU internal SPI driver
UART
- MSP430F1系列单片机内部串口控制程序-MSP430F1 MCU internal serial control procedures
ucos
- 基于STM32F103移植的UCOS II 点亮两个led-UCOS II based STM32F103 transplantation two led lights
Juzhen
- 按下16个矩阵键盘依次在数码管上显示1-16的平方。如按下第一个显示1，第二个显示4-Press 16 matrix keyboard turn on the digital display 1-16 squared. If you press the first one shows a second display 4 ...
Responder
- 抢答器的实现，当按下任一个按键后，其他的按键都没有效果，系统自动只识别接收到的第一个信号，并在数码管上显示出来，重新启动后开始下一轮抢答-Responder realization, when you press any button, the other buttons have no effect, the system automatically recognizes only the first received signal and the digital tube display,
stopwatch
- 用动态扫描方法和定时器1在数码管的前三位显示出秒表，精确到1 秒，即后两位显示1 秒，一直循环下去-Using dynamic scanning method and Timer 1 in the top three digital tube display stopwatch, accurate to 1 of the second, which shows one percent after two seconds, and loop forever
counter
- 该程序将实现简单的计算器的加减乘除，四则运算的功能-The program will achieve a simple arithmetic calculator, four arithmetic functions
BEEPP500msLED
- 8个发光管由上至下间隔1s流动，其中每个管亮500ms,灭500ms,亮时蜂鸣器响，灭时关闭蜂鸣器，一直重复下去-8 LED interval 1s flows from top to bottom, in which each tube light 500ms, off 500ms, when the buzzer sounds bright, turn off the buzzer off, has been repeated down
Music
- 同时用两个定时器控制蜂鸣器发声，定时器0控制频率，定时器1控制同个频率持续的时间，间隔300ms依次输出1，10，50,100，200,400,800,1k（hz）的方波 -The same time with two buzzer timer control, timer 0 control frequency, Timer 1 control with a frequency duration of 300ms intervals sequentially outputs 1,10,50