资源列表
duojichengxu
- 程序功能：接收PWM控制信号，将其转换成对应的控制目标角度，A/D采样回馈得到当前摇臂的角度，最后在程序中采用PID控制输出，是摇臂到达预定目标。-Program features: PWM control signal received, which was converted to the corresponding control target angle, A/D sampling to obtain the current angle of the swing arm back. Fi
PMAC_Motor_SH_sw_code_Dec_2008
- 瑞萨SH7085芯片和SH7125芯片控制电机的程序-motor control
8051-MCU
- 基于8051单片机的系统设计，系统包含了键盘，spi协议，18B20温度传感器- a design by 8051-MCU ,it s include key, SPI protocol ,18B20 temputure sensor
Encoder
- 智能车 机器人码盘测速代码，适用于ARM7，具体管脚分配请参考stm32中文手册Pograming of Encoder-Pograming of Encoder
chuankou
- 有keil编译的51串口缓冲收发数据流程序-There keil compiled 51 transceiver serial data stream buffer program
HJMCU
- 1T单片机彩屏显示数字实验源代码，是基于增强型51单片机的实验-1T MCU color display digital experiment
guanglifang
- 有51和595做的光立方的源程序，肯定不能下进去就用，一套硬件，一套软件，仅供参考而已-51 and 595 cubic light source to do, certainly can not go on with the next, a set of hardware, a software for reference only
ARM_smallest_SYS
- 此PPT讲述如何建立ARM单片机的最小系统，包括电源、复位、下载等内容-This PPT on how to build the smallest ARM microcontroller system, including power, reset, downloads and other content
pinpu
- 用51没有加任何驱动芯片做的频谱的源程序，供参考学习，-With 51 plus any driver chips do not have the spectrum of the source, for reference study,
IIC_BUS
- 此PDF为IIC总线规范的内容,用于初学者对IIC的理解-This PDF is IIC bus specification content
2438
- DS2438的驱动程序，包含DS2438的时序程序和温度读取程序-DS2438 drive program，containing time slots and reading temperature.
24L01test51mode
- 24L01的发送和接受程序，可以控制继电器开关的简单动作。-24L01 sending and receiving procedures, simple actions can control the relay switch.