资源列表
1234
- 。所以只能在proteus软件中进行硬件的设计，分析及仿真。再用keil进行程序的编写与调试。然后将proteus中画好得硬件原理图与keil中运行无误的程序相连接。通过观察原理图中仿真情况进行修改，至达到想要结果。下面对这两个软件作简要介绍： Proteus：Proteus软件是英国Labcenter electronics公司出版的EDA工具软件（该软件中国总代理为广州风标电子技术有限公司）。它不仅具有其它EDA工具软件的仿真功能，还能仿真单片机及外围器件。它是目前最好的仿真单片机及外围器件
DHT11
- DHT11温湿度头文件！采用52调试完全通过-DHT11 temperature and humidity header file! Adopt 52 debugging completely through
STM32F103PCC2500
- STM32驱动CC2500模拟SPI，只需要修改其中的引脚配置即可，有问题可以私信~-STM32 CC2500 SPI
PLJ420KHZ)
- 频率计(扩展到420KHZ) 在VC 2013中调试通过-Frequency meter (expanded to 420KHZ) in VC 2013 through debugging
19dianj
- 独立按键控制程序，已经在单片机开发板上测试通过-Independent key control procedures have been tested by the microcontroller development board
juzjianp
- 矩阵按键控制程序，已经在单片机开发板上测试通过-Matrix button control procedures, has been tested in microcontroller development board
chuanxxs
- 串行12864显示程序，已经通过硬件测试-Serial 12864 display program, has passed the hardware test
fengmingq
- 蜂鸣器控制C语言程序，已经通过硬件测试-Buzzer control procedures have been tested by the hardware. . .
DS18B20
- 基于51单片机DS18B20程序设计开发。-Reading program design is based on 51 single DS18B20 temperature sensor.
LED
- 嵌入式IAR开发环境中，按一定规则实现LED流水灯。-EW IAR LED
ATmega16L-8PU-UART---1.0.1
- ATmega16L-8PU-UART - 1.0.1AVR的串口测试程序。-ATmega16L-8PU-UART- 1.0.1AVR serial testing procedures.
Ccode-study
- arm开发板相关资料，对于新手很有帮助，特别是底层驱动的开发。-arm development board information, helpful for the novice, especially bottom-driven development.