资源列表
T2_use
- 控制多块8X8LED，三个中断源控制不同图画显示，以及控制音乐停止继续-Control of multi-block 8X8LED, three different interrupt sources controlled picture display, and control the music stops to continue ......
TIMEROUT
- *功能: 使用定时器0实现1s定时,并打开IRQ中断,控制LED闪烁 * 同时使用定时器1实现比较匹配输出-* Function: Timer 0 to achieve 1s regular and open IRQ interrupts, control LED flashes * Achieved while using Timer 1 Compare Match Output
UART0
- *功能: 串口发送数据 *说明: 使用外部晶振,不使用PLL,Fpclk=Fcclk/4-* Function: Serial Transmit Data * Note: Use an external crystal, do not use the PLL, Fpclk = Fcclk/4
UART0_FIFO
- *功能:使用串口UART0接收上位机发送的数据,当接收到8个连续数据后,取反LED控制,并将 * 数据原封不动地发送回上位机-* Function: UART0 serial data receiver PC to send, when after receiving eight consecutive data negated LED control and data intact* sent back to the host computer
WDT
- * 功 能：运行WDT，并控制LED1--LED4显示输出。程序开始先对LED1--LED4闪烁控制， * 并进行喂狗处理；然后只点亮LED1，并进入死循环，等待WDT复位。 * 说 明：将跳线器JP12短接。此程序只可以在Flash中运行，看门狗复位会导致JTAG * 无法调试。-* Function: Run WDT, and control LED1- LED4 display output. Program begins the first of LED1- LED4 fla
HW
- stc152k61s2红外解码，串口接收解码数据-stc152k61s2 IR decoding, the receiver decodes the serial data
pingpu
- 频普程序-The frequency spectrum program
MWC
- atmega328的MWC无线通信系统 PCB 及原理图 可直接制作成品-MWC wireless communication system PCB and schematic direct production of finished products
DSPMCUCPLD
- 基于DSPMCUCPLD的喷码机系统外围接口的研究与设计-Research and Design DSPMCUCPLD inkjet printer system peripheral interface based
MFRC522_STC
- 这个可是相当好的资料 基于STC的MFRC522全套程序及资料-The STC, but very good information on the full program and information MFRC522
11
- 光控步进电机，光电门在被遮蔽时输出高电平，从而使步进电机停转-Light control stepper motors, optical gate output is high when it is obscured, so that the stepper motor stall
msp430
- 一种基于MSP430单片机的远程温度采集系统-An MSP430 MCU-based remote temperature acquisition system