资源列表
multkey
- 这是基于stc89c52的单片机程序，为矩阵键盘的程序源码-This is based on stc89c52 single-chip microcomputer program for matrix keyboard program source code
18B20
- 通过温度传感器DS1820采集温度，在数码管上显示出温度值，第一个数码管显示正负。当前测得温度为19.87。当手放到DS1820时，数码管显示温度为20.06。-By collecting temperature DS1820 temperature sensor, showing the temperature on the digital control, the first sign of a digital display. The current measured temperatur
ds1302timers
- 8位数码管显示位时钟状态， 格式为:00（小时）—00（分钟）—00（秒）。 当按下K1键时，数码管时钟停止。当按下K2时，进行时钟调时。当按下K3时，进行时钟调分。当按下K4时，时钟继续开始。-8-bit digital display clock status, format: 00 (h)-00 (min)-00 (seconds). When you press the key K1, digital clock is stopped. When pressed K2, conduc
keyboard520
- 按下S1数码管显示0，按下S2数码管显示01， 按下S3数码管显示012，按下S4数码管显示0123， 按下S5数码管显示01234，按下S6数码管显示012345， 按下S7数码管显示0123456，按下S8数码管显示01234567， 按下S9数码管显示12345678，按下S10数码管显示23456789， 按下S11数码管显示3456789A，按下S12数码管显示456789Ab， 按下S13数码管显示56789AbC，按下S14数码管
fengmingqi
- 1、蜂鸣器发出滴答、滴答的响声。 2、蜂鸣器播放音乐。-A buzzer tick, tick sound. 2, buzzer play music.
iic-24b16
- 数码管进行两位计数。此芯片有掉电保护功能，当板子断电后，数码管计数仍然保持在断电前的数字，接上电源后，继续前面的状态进行计数。-Digital tube two count. This chip has a power-down protection, when the board is powered down, the digital count remains at the front of the digital power after the power is on, in front
ht1621-czw
- HT1621底层驱动程序，适用与AVR单片机。-HT1621 AVR MCU。
28BYJ-48bujindianqi
- 继电器不停的吸合和释放。吸合时二极管亮，释放时二极管-Relay stop pull and release. Suction timely diode light, the release diode
CAN_SEND_RECIEVE
- 两个单片机板子进行通信，一个发送程序，一个接受程序。通过发送的程序的板子来控制接受程序的板子,点亮接收程序板子上的第一个发光二极管。-Two microcontroller board to communicate, a sender, an accepted procedure. Sent by the board to accept a program to control the program' s board, the first light-emitting diode on
232
- 51单片机的串口通信，发送消息程序工程文件-51 single-chip serial communication, sending messages
AD9850_DDS
- 用Arduino控制DDS_AD9850做成的波形发生器-Made of Arduino control DDS_AD9850 waveform generator
232receive
- 51单片机串口通信，接收信息程序源代码。-51 single-chip serial communication program source code to receive information