资源列表
ATMLH012
- 基于IIC总线控制，实现对ATMLHO12芯片的读写操作，主要内容包括：硬件电路的连接、工作时序、代码-Based on the IIC bus control chip to achieve ATMLHO12 read and write operations, the main contents include: connecting hardware circuits, timing of work, the code
Nc-power-supply
- 用单片机STC12C4052 三位数码管实现 程控电源的控制按键 可以调整电压-Programmable power supply to achieve the MCU STC12C4052 three digital control buttons to adjust the voltage
IEC104_C_language
- 南瑞iec 104规约使用C语言使用于嵌入式编程-iec 104 protocol that used c !
code
- msp430g2553测量方波震荡频率的程序，可测量的范围为：小于65kHz。-msp430g2553 square wave frequency measurement procedures, the frequency range that can be measured: less than 65kHz.
cc2530-code
- 基于zigbee cc2530的模拟输入调试程序，给出了使用cc2530模拟输入所需配置的寄存器。可用。-Based on the analog input debugger zigbee cc2530, gives the desired configuration using cc2530 analog input registers.
chengxu
- 基于51单片机的超声波测距，带有温度补偿计算，精度达到0.5cm-51 microcontroller based ultrasonic ranging, temperature compensation is calculated with an accuracy of 0.5cm
arduino-RFID-IR
- 运行于arduino上的程序，可同时识别RFID标签，和红的发射信号。需要硬件：RFID模块，IR红外接收头。 具体接线方式，文件内已给出。-Arduino running the program on, which can identify RFID tags, and red emission signals. Requires hardware: RFID module, IR infrared receiver. Specific wiring, has been given in th
code
- BMP085气压计模块的运行驱动。能通过IIC读取BMP085内所测得的数据。并通过1602液晶显示。-Run Driver BMP085 barometer module. IIC can read the measured data in the BMP085. And by 1602 LCD.
filter
- 线性CCD黑线提取算法，几种滤波算法，包括大津动态阀值算法-Linear CCD black line extraction algorithm, several filtering algorithms, including dynamic threshold algorithm Otsu
lcd12864_serial
- pic18f452用串行方式驱动lcd12864液晶-lcd12864 display for pic18f452
gyroaacc
- 这是加速计和陀螺仪融合提取算法，并通过电灯控制来表示是否读取合理结果-This is a fusion of accelerometers and gyroscopes extraction algorithms, and to indicate whether a reasonable result read by lamp control
adxl345
- ADX1345模块的PIC18f452驱动程序源码-adx1345 drive code for pic mcu