资源列表
st7920
- 液晶驱动芯片st7920源程序。msp430用，iar平涛开发-LCD driver chips st7920 source. msp430 use, iar Ping Tao development
sst25vf
- sst25vf32驱动程序 iar平台开发 可用于msp430-sst25vf32 driver platform can be used iar msp430
nandflash(success)
- k9f1g的msp430驱动 iar开发的 直接使用即可-k9f1g of msp430 drive
uart
- 单片机UART配置，封装成了.c文件和.h文件。包含串口发送函数与串口中断-About MCU uart configuration
control-led1-and-led2-of-msp-430
- 当sw1 和sw2 被触发时发出不同频率的LED灯闪烁- Initiates LED1 and LED2 to blink on and off at a set rate. * When SW1 is pressed, the frequency is toggled to double. * When SW1 is pressed again, the frequency is reset. * While SW2 is being pr
Lab_5_demo
- 用汇编语言控制led 发出不同频率的闪光-Issued a flash at different frequencies in assembly language control led
Lab_3_Demo_Code
- 如何用汇编语言输出数据至端口，控制端口的输入和输出-How to use assembly language output data to the port
lab11
- 在dac 上显示一个波图，刚刚输出的时候是sine 的图 开动按钮后发出不同的图像-Write a C program that creates a waveform generator. It should start by outputting a sine wave to DAC0. Each time SW1 is pressed then released, the wave form should change, first to a triangle wave, then
Lab_4_Demo_Code
- 如何使用汇编语言在msp430的单片机上调用子程序-How to use assembly language subroutine call
USART
- STM32USART的一个串口开发例程，使用寄存器的方式。-This a usart demo .
UART_SEND
- MSP430F149 串口发送代码，用串口发送字符、字符串、字符的ASCII码-MSP430F149 send serial code, serial port to send character string of ASCII character codes
caidanxianshi
- 打印菜单的液晶显示，C语言程序，单级菜单和多级菜单都有-The liquid crystal display of the print menu, C language program, single-level and multi-level menu has a menu