资源列表
can
- can 通信， 包含了 接收 和 发送的详细实现。-this is for can send and recerve
SG26K20-2014-5-10
- 电压电流热阻热偶信号源程序，是工程必备的-Voltage and current resistance thermocouple signal source is essential engineering
Oled_DHT11_UART
- 0.86寸 OLed屏幕显示DHT11采集到的温度和湿度，并将温度湿度实时显示到串口上（测试OK）。-0.86 inch OLed screen DHT11 collected temperature and humidity, and the temperature and humidity real-time display to the serial port.
STM32-CAN-communication
- STM32 单片机CAN通信主节点程序-STM32 CAN communication master node program!!!
STM32CAN5564
- 这是一个基于STM32 单片机CAN通信主节点程序-This is based STM32 MCU CAN communication master node
STM32SQC
- 这是一个基于stm32单片机驱动的四路占空比可调的源程序-This is a microcontroller based stm32 driven four adjustable duty cycle of the source
STM32SPI2
- 基于STM32单片机上的SPI2模式的AD7705 16位的采集驱动-SPI2 model based on the STM32 microcontroller AD7705 16-bit capture driver
STM32DJWIFI
- 基于STM32单片机的SPI2模式的AD7705 16位的采集驱动-SPI2 based STM32 MCU mode AD7705 16-bit capture driver
stm32UIP32
- 基于stm32单片机上的UIP网络协议修改移植-Modify transplant UIP based on single-chip network protocol stm32
STC15FSMGZY
- 一个基于STC15FMCU通过按键来控制数码管的移动程序-Based STC15FMCU by buttons to control the digital moving program
QQ2440UIP
- QQ2440开发板 移植了UIP 实现了全部的APP功能，给学些网络的朋友提供参考，谢谢。-QQ2440 development board transplant UIP APP implements the full feature network to learn some friends to provide a reference, thank you.
wifi_audio_app
- 基于TI CC3200-LAUNCHXL开发板和CC3200AUDBOOST的WIFI音频对讲DEMO程序，提供的音频演示应用需要两个基站模式的 C3200-LAUNCHXL + CC3200AUDBOOST 设置，并通过 Wi-Fi 向第二个LaunchPad 提供 16 kHz、16 位采样的 PCM 音频的单播流-Based on TI CC3200-LAUNCHXL WIFI Development Boards CC3200AUDBOOST of DEMO program audio