资源列表
dianji28BYJ-48
- 步进电机28BYJ-48 产品详细简介（PDF）-Stepper motor 28BYJ-48 Product Details Product Information (PDF)
BUJIN--CONTROL
- 基于单片机STC89C52的步进电机控制器学习资料-Based on a single-chip stepper motor controller STC89C52 learning materials)
CONTROL-BUJINDIANJI
- STC89C51 步进电机控制器仿真与源程序-STC89C51 stepper motor controller emulation and source
nrf24l01
- 模拟I2C总线，用的是SPI，STM32上的I2C总线不是很稳定，模拟的更好-spi to i2c
SC16IS750_760_cn
- SC16IS750_760_cn的Chip manua，对于需要转485的童鞋需要-Chip manua
GCC-__attribute__-meaning-
- GCC __attribute__ meaning -GCC __attribute__ meaning
key_count
- 记录按键次数，LED数码管显示按键次数。-Recording keystrokes, LED digital display
control_car
- ps2手柄控制遥控小车，Arduino手柄接收程序。51单片机小车控制程序。-ps2 handle remote control car, Arduino handle receiver. 51 SCM trolley control procedures.
ILI9341-16BIT
- ILI9341，驱动程序，电压3.3v 51单片机，帮助新手学习tft的驱动-ILI9341, drivers, voltage 3.3v 51 microcontroller, help the novice to learn driving tft
AiP1616
- AIP1616是一款数码管驱动ic，用法简单，使用方便-AIP1616 is a digital driver ic, are easy to use, easy to use
EXP2_IOkou-xuexi
- 绘制实验仿真原理图，编写运行程序，实现将十进制数156拆为三个BCD码,并存入30H开始的三个单元，采用汇编语言和C51语言完成。-The simulation draw schematics, write to run the program, to achieve the decimal number 156 split into three BCD, and stores 30H three units started. Subjects were using assembly langu
EXP3_jishuqi
- P1口做输出口，接八只发光二极管，绘制仿真电路图，硬件连接表见3-1。 ①编写C51程序，采用软件延时的方式实现发光二极管的每秒闪烁。 ②编写C51程序，使8个发光二极管从右到左（上到下）逐一点亮。 ③编写C51程序，使8个发光二极管从两边到中间顺序点亮，直至全部点亮，然后从中间到两边顺序熄灭，直至全部熄灭，如此循环下去。 -P1 port as the output port, then eight light-emitting diodes, circuit simulati