资源列表
STM32_TPAD
- 使用STM32来检测触摸屏使用操作的源码-STM32 use touch screen operation to detect the source
ILI9325-DriversaGUI
- 单片机驱动ILI9325 LCD的程序，带有显示ASCII、中文、图像，画点、圆、矩形、直线、刷屏等多种功能函数。-Microprocessor ILI9325 LCD program display a variety of functions with the function ASCII, Chinese, picture, painting dots, circles, rectangles, lines, scraper and so on.
Matrix-keyboard
- 实验程序可分成三个模块。 ①键输入模块：扫描键盘、读取一次键盘并将键值存入键值缓冲单元。 ②显示模块：将显示单元的内容在显示器上动态显示。 ③主程序：调用键输入模块和显示模块。 -The experimental program can be divided into three modules. The key input module: scan the keyboard, read the keyboard and keys into a key buffer unit
Dot-matrix-display-character
- 基本部分： 固定显示。在点阵上轮流显示数据0-9和字母A-F。 -Basic part: Fixed display. On the dot matrix display data 0-9 and A-F.
Timer-experiment-inquiry-method
- 基本部分： 用CPU内部定时器查询方式计时,实现每一秒钟输出状态发生一次反转. -Basic part: With the CPU internal timer query mode, the output per second to achieve a reversal of the state.
Digital-tube-dynamic-display
- 在两个4位数码管上动态显示数字0-9 动态显示：数据端口：JP10（P0）与J12 用8PIN排线连接起来。位线端口：JP8（P1口）和J16用8PIN排线连接。-Dynamic display of digital 0-9 in 4 two bit digital tube Dynamic display: data port: JP10 (P0) connected with J12 by 8PIN cable. Bit line port: JP8 (P1) and J16 cab
cpc-progrom
- 本测试程序，可以在特定硬件平台上运行，用于控制步进电机，并采集激光管的击中次数。运行稳定。-The test procedures can be run on a specific hardware platform, for controlling stepper motors, and hits to collect the laser tube. Stable operation.
Security-robot-car-program
- 本程序是基于51单片机的安防机器人程序，可以寻迹，检测烟雾等-This program is based on 51 single-chip security robot program, you can tracking, testing smog
BS804-Driver
- BS B804 单总线触摸芯片驱动程序，已经验证可用-BS B804 Single bus touch chip driver, has been verified available
CC1101-DRIVER
- CC1101 TI433MHZ 射频芯片驱动源码。模拟SPI接口，已经验证可用。-CC1101 TI RF chip driver source code. Simulation SPI interface are available.
stm32usart485
- STM32的串口程序，包括485通信，自己写的，希望可以有帮助！-is usful for new frend!
LDS62XX-Driver
- IDT公司的LDS62XX 触摸芯片 I2C总线通讯协议 驱动程序-IDT s LDS62XX touch chip I2C bus communication protocol driver.