资源列表
CAN-send
- CAN模块sja1000通过串口发送数据，控制端口设为A端口，数据端口设为B端口-CAN module sja1000 serial port to send data via the control port to port A data port to port B
DAC7811
- DAC7811，8位dac，内附msp430模拟SPI通信程序，可移植到其他单片机-DAC7811, enclose msp430 simulation SPI communication, portable to other MCU
MAX7219V2.0
- MAX7219显示双四位数码管,实际已运用-MAX7219 dual four digital display, actually use
DDS-AD9850
- DDSAD9850模块的操作程序，可以输出方波和正弦波，可以调节频率，使用IAR编译器编写的，msp430的程序-DDS module procedures, can output pulse and the sine wave, can adjust frequency, using the IAR compiler, msp430 program
NRF24L01
- NRF无线模块的程序，使用IAR编写，调试两周以上，保证可用，只需要更改参数即可设置接收或发送，msp430上的程序-The NRF wireless module program, use the IAR to write, debug more than two weeks, guarantee available, you just need to change the parameter Settings to receive or send
MPU6050
- MPU6050，陀螺仪，使用模拟I2C通信，程序里有模拟I2C的程序，很好移植，IAR的MSP430的程序-MPU6050, gyroscope, the use of simulated I2C communication, program in a simulated I2C, good transplant, IAR MSP430 program
STC15W408AS-AD
- STC15W408AS的AD转换串口输出,完全可以使用，工程项目程序- AD STC15W408AS converter serial output, can be used, the project program
STC15W408AS-DS18B20
- 基于STC15W408AS的DS18B20测温串口发送- STC15W408AS based on the serial transmission of DS18B20 temperature measurement
PROGRAM
- 红外遥控串口输出键值,程序是完全用的，公司项目程序- Infrared remote control serial output key, the program is entirely for the project program
chengxu
- 油量剩余检测源程序，才有51单片机，带protues仿真文件，完全好用- Oil residue detection source, there are 51 single-chip, with Protues simulation file, complete with
stm32_L298n
- stm32单片机的L298n的驱动，L298n作为电机驱动，经常被使用在点电机驱动模块中，本次上传的是L298n的驱动，节省了开发L298n的时间。-L298n drive stm32 microcontroller, L298n as a motor-driven, often used at the point of the motor drive module, this upload is L298n drive, saving development time L298n.
PCP-CPP(wsnlab.org)
- simulation ns2 with pcd scr ipt