资源列表
DustSensor
- 本程序主要是灰尘传感器的代码，运行环境为arduino开发板-This program is mainly the code of dust sensor, the operating environment is the arduino board
PM2.5
- 本程序主要是攀藤G3/G5和夏普二代传感器代码，运行环境为arduino开发板，希望和大家分享，一起学习。-This program is mainly climbing G3/G5 and sharp second sensor code, running environment for the arduino board, hope to share and learn together.
flash
- MSP430F4716系列硬件spi驱动flash，flash大小为256mbit，实际操作128mbit。由于网上没有MSP430F4716系列硬件驱动256mbit flash,就自己动手写的，可以使用-MSP430F4716 series hardware spi drive flash, flash size is 256mbit, the actual operation of 128mbit. Because there is no MSP430F4716 series hardwa
DAC
- 在KEIL的开发环境中实现基于STM32F4系列芯片的ADC管脚上采集电压值，并在TFTLCD上显示出来。-In the KEIL development environment to achieve based on STM32F4 series chip ADC pin voltage collection value, and displayed on the TFTLCD.
STM32F103_CAN_AVR_mega16_MCP2515
- STM32F103内置CAN与AVR_mega16+MCP2515同时互相收发通讯程序,同时通过自身串口uart显示对方发来的数据-STM32F103 built-in CAN and AVR_mega16+ MCP2515 at the same time send and receive communication procedures at the same time through their own serial port uart show the other side of the
21-ISO_RTC
- STM32F030C8T6S实测可用的RTC程序，含内部晶振和外部晶振-Quotient & lt RTI ID 0.0 & gt u5 & lt /RTI & gt & lt RTI ID 0.0 & gt u5 & lt /RTI & gt & lt /RTI & gt
AD-capture
- STM32F051芯片的AD外部电压采集程序-STM32F051 u82AF u7247 u7684AD u5916 u90E8 u7535 u538B u91C7 u96C6 u7A0B u5E8F
TIM_6Steps
- 驱动直流无刷电机的六路PWM波程序 stm32 keil- U9A1 u52A8 u76F4 u6D41 u65E0 u5237 u7535 u673A u7684 u516D u8DEFPWM u6CE2 u7A0B u5E8F
Six_Complementary_Pwm
- 基于STM32F103的六路PWM波互补程序-Six channel PWM wave complementary program based on STM32F103
CH378-Demo-Software
- 这是南京沁恒的高速U盘SD卡控制芯片CH378的驱动程序。可以实现U盘和SD卡的读写，硬件SPI和软件模拟SPI的例程都有，并且把读写的结果通过串口输出，可以直接应用。-This is the Nanjing Qin Heng high-speed U disk SD card control chip CH378 driver. Can realize U disk and SD card read and write, hardware SPI and software simulation
LED
- 红外小灯的演示，本例通过编写简单的C51红外小灯控制程序，对初学者有很大帮助-Infrared small lamp demonstration, this example through the preparation of simple C51 infrared small lights control procedures, very helpful for beginners
UART
- 利用UART串口对单片机进行通信，此例可以为初学者的提供帮助和理解-To communicate with the microcontroller using UART serial port, it can provide help for beginners to understand and