资源列表
电子钟
- 电子时钟，使用51单片机可以实现记时，定时的目的(The use of 51 single-chip electronic clock, can achieve timing, timing purpose)
多合一code
- 采用51单片机作为主控制器，通讯方式为485总线，通讯协议为Modbus，波特率为9600，8位数据，1个停止位，无校验位； 本程序作为从机部分编写的；(Using 51 single-chip microcomputer as the main controller, communication mode is 485 bus, communication protocol is Modbus, baud rate is 9600, 8 bit data, 1 stop bits, no pa
LO1-SOP8MCU16-3-3
- ADF4350的驱动程序，可实现频率设置，功率设置，已在板子上验证通过，可以正常工作。(ADF4350 driver, you can achieve frequency settings, power settings, has been verified on the board, you can work properly.)
C与汇编对照版本程序
- 18B20温度传感器的使用例程，分别用了C语言和汇编语言来对照编程。(18B20 temperature sensor using routines, respectively, using C language and assembly language to control programming.)
STM32ATK-7' TFTLCD电容触摸屏显示
- STM32F103处理器显示电容触摸屏的驱动，可以参考这种C语言例程写法(STM32F103 processor display capacitive touch screen driver, you can refer to this C language routines written)
NOKIA_LCD5110_STM32
- 基于stm32f103的5110显示屏驱动(5110 display driver based on STM32F103)
四轴飞行器源码
- 四轴飞行器源码教程，程序较为规范，便于新手学习，但是请不要随便传播！(Four axis aircraft source tutorial, procedures are more standardized, easy for beginners to learn, but please do not just spread!)
TM1620驱动程序
- TM16XXX系列驱动程序，有了这个，整个系列都可以顺畅使用了，验证可用(tm16xxx led c language, for MCU)
串口通信
- 串口485通信程序，收发程序，串口寄存器说明(Serial 485 communication program transceiver program, serial register descr iption)
12864显示字符
- 51单片机控制液晶12864显示字符，完美(51 MCU control LCD 12864 display characters)
DS1302实时时钟
- 51单片机控制ds1302实时时钟，完美(51 MCU control DS1302 real-time clock, perfect)
无线NRF与1602单机测试
- 51单片机控制，无线模块传输显示于1602上(51 single chip microcomputer control, wireless module transmission is displayed on 1602)