资源列表
DAC实验
- 首先对STM32 DAC功能进行了简介，通过对各寄存器的分析，编写了数模转换的程序。(First, a brief introduction to the STM32 DAC function, through the analysis of the register, write the analog-to-digital conversion procedure.)
code
- 一个简易时钟并且带有闹钟，可在通讯串口处显示时间，并且设置闹钟。(A simple clock, and with alarm clock, you can display the time in the communication port, and set the alarm clock.)
USB to RS232_spec (C)
- usb轉 rs232的廠商介紹,這個solution很棒(one solution for usb to rs232)
实验26 - HC-SR04超声波测距 - LCD1602显示
- 使用定时器触发超声波模块 测距显示到1602(Use the timer to trigger the ultrasonic module, ranging from 1602)
LCD5110_Buf
- Nokia液晶 驱动程 可移植 画点划线 写函数 写数据 写图标(Nokia LCD driver, portable point painting, line marking, write function, write data, write icons)
WLAN_ESP8266
- 使用串口1打印输出。采用串口2与wifi模块通信(Use serial port 1 to print out. Use serial port 2 to communicate with WiFi module)
项目实战5-无线温湿度多点采集系统
- 使用VB 编写的上位机 用 stc 15采集温度 ，控制射频无线模块 传输到终端 实现监控(Using VB prepared by the host computer, using STC 15 to collect temperature, control radio frequency wireless module to the terminal to achieve monitoring)
项目实战3-无线按键遥控-串口调试助手
- 使用sct15w 控制NRF4 实现 收发(Using sct15w control NRF4 to achieve send and receive)
STM32L476USB驱动-20160804
- stm32l476芯片 PWM驱动 用于伺服电机 步进电机等pwm驱动的设备(Stm32l476 chip PWM driver for servo motors, stepper motors and other PWM drive equipment)
SPI_FLASH
- STM32F10x系列SPI外接Flash(The STM32F10x series MCU SPI Bus configuration and contact with exterior Flash)
vl53l0驱动
- 在stm32f103单片机的平台下，驱动了ST VL53L0激光测距传感器(Under the platform of STM32F103 single chip microcomputer, the ST VL53L0 laser range sensor is driven)
arduino-cookbook.pdf
- book: arduino cookbook. a huge but detailed book for embedded control programming by using arduino system.