资源列表
keil+8051
- 本书首先详细介绍了8051单片机的硬件，包括内存、寄存器等，然后引入其开发环境KEIL，由浅入深地介绍了如何使用KEIL平台开发8051单片机(This book first introduces the hardware of 8051 single chip microcomputer, including memory, register, etc., and then introduces its development environment KEIL. It introduces h
UART
- 使用串口实现CC2530对LED灯的控制，主要是对串口的功能加以应用(Using the serial port to realize the control of the CC2530 to the LED lamp, it is mainly to apply the function of the serial port.)
ADC
- 使用CC2530的ADC功能，实现芯片的ADC功能的应用(Using the ADC function of CC2530 to implement the application of the ADC function of the chip)
Watch Dog
- 利用中断控制，实现CC2530芯片上的看门狗功能(Using interrupt control to implement the watchdog function on CC2530 chip)
DS18B20
- 使用温度传感器采集温度数据，通过串口将数据传输到PC端(Use the temperature sensor to collect the temperature data and transmit the data to the PC side through the serial port)
sensor
- 使用光敏和热敏传感器实现对光和热的数据的采集，使用串口将数据传输至上位机(Using photosensitive sensor and thermal sensor to realize the acquisition of light and heat data, using serial port to transfer data to the upper computer)
信号源
- 用于将芯片与单片机一起作为信号源，产生各种所需要的信号，如方波、线性调频信号、锯齿波等(Produce a variety of waveforms, Fang Bo, FM, sawtooth, etc.)
softt
- nios II c code to read switchs
servo
- 使用arduino的舵机库控制舵机转动，进行扫描操作(using the PWMservo lib to control a servo)
FreeIMU-20121122_1126
- 这是一个使用arduino的i2c口控制传感器ＩＭＵ惯性测量单元的库(this is a library to control IMU by using arduino I2c)
ADXL345
- 这是一个arduino的库，用来控制adxl345 （三轴加速度计），通过使用I2C 口(This is a library of arduino,you can use it to connect and control the sensor ADXL345)
SuperCOM 2015
- 一个好用的上位机程序副通讯协议，下载下来直接使用就可以(A good use of the host computer program side communication protocol)