资源列表
ALIENTEK MINISTM32 实验1 跑马灯-库函数操作
- 学习stm32库函数基础教程跑马灯实验参考代码(Learning STM32 library function based tutorial marquee experiment reference code)
HEX文件
- 基于stc15系列单片机的温湿度传感器数据显示代码(Data display code of temperature and humidity sensor based on stc15 Series MCU)
moban
- 驱动LED灯闪烁，LED灯接在PB5和PE5(Drive LED lights flicker, LED lights are connected to PB5 and PE5)
123
- good work stm32 processor
ggrfid
- this program can make you enjoy it
AD.X
- AD转换，实现简单的模拟电压转换数字电压(AD conversion, to achieve a simple analog voltage conversion digital voltage.)
HYR-2211S三脚蜂鸣器
- 本封装为三脚蜂鸣器的PCB封装，可直接使用(The PCB package package for the tripod buzzer and can be used directly)
新建文件夹
- 51单片机控制温湿度传感器DHT11然后在LCD1602上显示当前的温湿度及单位其中湿度在第一行显示温度在第二行显示。单片机为YL-9最小系统。(The 51 single chip microcomputer controls the temperature and humidity sensor DHT11 and then displays the current temperature and humidity on the LCD1602 and the humidity in
单片机
- 1.通过ADC0808转换器，将模拟信号转化成数字信号，可以通过电阻的调节来控制LED数码管转速的显示，且精度达到0.01。 2.通过示波器更方便、明了地显示电阻与电压的关系，结果如图所示。(1. through the ADC0808 converter, the analog signals are converted into digital signals, and the display of the LED digital tube speed can be controlled
HT1632C制作的1648LED点阵程序
- HT1632C制作的1648LED点阵程序(1648LED dot matrix program made by HT1632C)
WXG_040_01(27E64)(电流s)
- 检测四个电机工作时动态电流，以判断其工作状态。(The dynamic currents of four motors are detected to determine their working state.)
18B20
- 使用51单片机，18B20温度传感器对外部温度，采集显示(Temperature acquisition and display of 51 single chip microcomputer 18B20)