资源列表
stc51_DS18B20
- 快速读取八路温度DS18B20，采用8个引脚，在数码管上顺序显示各路温度，并检测器件是否正常，然后将各路温度通过串口发给上位机-Quick read eight-way DS18B20 temperature, using 8 pins, order on the digital tube display various temperature, and detection device is normal, then each temperature via a serial port sen
12864
- 单片机串口12864显示程通过串口数据来驱动12864液晶显示器工作 c语言程序-Single-chip microcomputer serial port 12864 display program
MSP430_demo
- MSP430最全的示例程序，可用于MSP430程序开发时作为参考，同时也能作为硬件验证-MSP430 demo
nfr24l01
- 51单片机与NFR24L01连接原理图，基于完整的ASM程序代码。双方都要采用项目的电路。-51 and NFR24L01 connection diagram, based on the complete ASM code. The two sides should adopt circuit project.
C51-MCU-Exemple
- 51单片机的I2C读取温湿度通过串口发送-51 MCU I2C read the temperature and humidity through the serial port to send
Multi_ADCON
- PIC18F4520交流电压多路采集程序-PIC18F4520 AC voltage multiplexer collection procedures
12864-Pic
- PIC单片机简易示波器程序,带仿真，带液晶显示-PIC microcontroller Simple oscilloscope program
Frequency-Counter
- PIC18F4520单片机频率计程序，带仿真，带数码管显示-PIC18F4520 microcontroller frequency meter program with simulation with digital display
ADC0809P12864Pproteus
- ADC0809+12864液晶显示+电压值+proteus图-ADC0809+ 12864 LCD+ voltage+ proteus FIG.
LCD1602showEEPROM
- lcd1602显示eeprom，使用的是stc89c51单片机，在keil4中编程并下载。-lcd1602 display eeprom, using stc89c51 microcontroller programming and download keil4 in.
stm32-IR
- 基于stm32的关于红外遥控器的编解码程序，输出PWM波控制电机。-Stm32 based on the infrared remote control codec procedures, the output wave PWM motor control.
test
- 基于51单片机PWM直流电机调速程序，通过单片机产生PWM波，并通过按键控制电机的转速。- Based on 51 single-chip PWM DC motor speed control procedures, PWM wave generated by the microcontroller, and the motor speed through the key control.